0
What else can I help you with?
How many watts can a Honda G300 run?
A Honda G300 is a 7 HP engine. You will have to look for the nameplate on the generator end to see what the wattage is.
Choose a radius in this figure?
Segment HP
What is full load current of 20 HP induction motor in delta?
480V about 20A 240V about 40A look at the nameplate duty cycle and efficiencies vary
How many amps does 1 phase 220volt 7.5 HP draw?
Look at the motor nameplate and it shoud have the amp draw on it. If the nameplate is missing, then the amp draw depends on what type of motor it is. The basic calculation to get you in the ball park would be as follows: 1 HP = 0.75 KW 7.5 HP = 5.63 KW Assume the efficiency of the motor is 80%, then the power supplied will need to be 5.63/0.8 = 7.04 KW amp draw = 7040/220 = 32 amps <<>> For calculation purposes the electrical code book states that a 7.5 HP motor draws 40 amps.
Can you start and stop a 20 hp motor several times a day?
The ability to start and stop a 20 hp motor, or any other large motor, several times a day depends on the motor. Look at the nameplate on the motor. It will tell you the criteria for restart, if applicable.
How do I figure out what toner to use with my HP printer?
Please consult the owners manual for your HP printer to determine the correct toner.
What does no load speed on a electric motor mean?
Generally a motor drives some equipment, it could be a fan, or a pump, connected to motor's shaft. The speed of the motor when no equipment is connected to its shaft is known as no load speed.
How much hp does a chevy 302 small block have?
290 gross hp, although that figure has always been disputed as vastly underrated.
How many watts does a hp printer consume?
On average, a HP printer consumes around 20-50 watts when printing, 3-5 watts in sleep mode, and 0.2-2 watts when off. The exact power consumption can vary depending on the specific model and usage.
Is a one half HP motor sufficient to run a dehumidifier with 15 Amps and 115 Volts?
A 1/2 HP 115volt motor draws 9.8 amps. This is a nominal book amperage for a 1/2 HP motor, check the nameplate for an accurate value. A breaker, to protect this size motor, has to be rated at 250% of the motors full load amps. In this case a 25 amp breaker in needed. If using the actual nameplate amperage, multiply it by 250% to find the size of the breaker to use. If the motor used 230 volts as a supply a two pole 15 amp breaker would work.
How can one build own plastic nameplate?
If someone wants to build their own plastic nameplate it is possible if they have one of the new three dimensional printers that are available. They would have to ensure that the nameplate is legal.
How do you figure watts from horsepower?
The conversion factor is 746.27: hp x 746.27 = watts
