There are specific code requirements for the use of white, gray, green, bare, and sometimes orange conductors. Other colors are a matter of convention and may differ from one area to another and certainly from one country to another.
In the central United States where I live, black, red, blue, and white are used for 110-240v; brown, orange, yellow and gray are used for 277/480v and higher voltages. You may encounter other colors but without knowing what specifically you are dealing with I cannot answer further.
the hot wire carries the electrical voltage
The ambient insulation rating of wires and cables is imprinted on the wire and cables. The labels on the cables will tell you the wire size, number of conductors and temperature rating of the wires and cables. The higher the cable and wire temperature ratings the higher the amount of current that is allowed to be drawn by the wire and cable according to the electrical code book.
A jumper wire should use to bridge electrical ground across?
Electrical wire sheathing should not project more than about one inch into the electric panel.
In typical American wiring the black wire on an outlet goes to the gold (copper) screw and the white wire goes to the silver screw. The ground wire goes to the green screw.
There is not enough information to answer this question.
yes
The electrical terminology of a wire with no insulation on it is a bare wire.
You need to get a plug from a junkyard to figure this out. Mitsubishi wont even help because they figure it would be unsafe to wire it manually even if done by a PRO.
The Chevrolet Lumina fuel pump is powered by the electrical system. The fuel pump has a ground wire and a positive wire. The positive wire goes to the fuel pump relay switch.
A magnetic field can induce an electrical current in a wire.
Electrical wire is the type of wire that is used in electrical equipment. To strip the wires, you need to use wire strippers. There is also special tape called electrical tape that is used to secure the wire.
Electrical wire.
If you know the voltage and resistance, then current = voltage divided by resistance. Otherwise, you can attach an ammeter into the circuit (in series).
It's dependent on the wire's composition. That is, what material it is made of. <<>> The electrical resistance in a wire depends on the wire's length and cross sectional area.
Black. wire goes to breaker, white wire goes to neutral bar, and copper wire goes to ground bar.
the hot wire carries the electrical voltage