0
What else can I help you with?
How do you use a water balloon launcher?
To use a water balloon launcher, follow these steps: Fill a water balloon with water. Place the water balloon in the pouch of the launcher. Pull back on the launcher and release to launch the water balloon towards the target.
How much water can you fill a water balloon before it pops?
The amount of water that a water balloon can hold before it pops depends on the size and quality of the balloon. Overfilling a water balloon can make it more likely to burst. It is best to follow the manufacturer's guidelines for filling the balloon.
What would happen to a balloon if you brought it down to the bottom of the ocean?
It would probably fill up with water, and then you'd have a water balloon.
How much water does it take to fill a water balloon?
The amount of water needed to fill a water balloon depends on the size of the balloon. Small water balloons typically hold around 8-10 ounces of water, while larger ones can hold up to 16-20 ounces. It's important to follow the instructions on the packaging to ensure you don't overfill the balloon.
What happens when you fill hot water in a balloon and put it in a jar filled with water?
it sinks
If you fill a balloon with hot and cold water and dropped them which one will pop first?
hot balloon will pop first
How do make a water balloon?
You put the end of it on the fauset then turn the water on until the water balloon is as full as you want it to be then you tie it and its ready to go.
How do you stretch out a water balloon?
To stretch out a water balloon, gently pull on opposite ends of the balloon to gradually expand its size. Be careful not to pull too hard and pop the balloon. Another method is to fill the balloon with water and then slowly massage and manipulate the balloon to stretch it out.
How much water would it take to fill a balloon?
It depends on the size of the balloon. If it's a small balloon, about a half gallon will due. If it's a larger balloon, about a gallon or so. Now, if it's a very small weak balloon, about 1/2 quarter gallon should do it.
How can you put water in water balloons?
take the balloon,put the top inside of the sink and twist the lever of the sink.(dont pour in too much water)Next, tie the balloon and have the most s!#$ as$ lame water balloon fight ever u loner!
Does hot water blow up a balloon?
Hot water blows up a balloon because it is taking up space. Second, Hot water gives off extra gas to fill up a balloon quicker.
How do you fill water balloons with water?
Stretch the mouth of the deflated water balloon over a tap or other pressurized water source. Turn on the tap so that water rushes into the balloon. Once filled, twist the balloon at the neck a few times. This way water does not escape when you remove the mouth of the balloon from the tap. Once removed, tie the twisted neck of the balloon in a knot to prevent water from escaping.
