Ford Contour
Chevy Tahoe
VW Cabriolet
Turn Signals and Hazard Lights

How do you find the location for replacing the relay switch for the hazard and turn signal lights on a Pontiac Grand Am?

151617

Top Answer
User Avatar
Wiki User
2010-03-03 04:03:19
2010-03-03 04:03:19

It's attached to the back of the hazard light button.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

the location of the hazard lights is on top of the steering colum.

User Avatar

try replacing all sets of fuses for the hazard and the tail lights.

User Avatar

you need to change the flasher can for the signal lights

User Avatar

The switch is located on top of the steering column.

User Avatar

Faulty hazard lights on a 1994 Acura Integra can be fixed by replacing the hazard light relay or the defective bulbs. Hazards are used to notify other drivers that the vehicle is in distress.

User Avatar

Your car has two flasher relays. One for the turn signal lights and one for the hazard lights. Replace the one for the hazard lights. Any auto parts store can tell you the location and sell you a new one.

User Avatar

you should try checking the fuses and replacing the bulbs the fuses for thos lights should only be about a 10 or a 15

User Avatar

It is the fuse for the hazard lights or as they are sometimes called, emergency lights.

User Avatar

If you will notice the hazard lights are not actually flashing, reason being, the hazard flasher relay is defective. Replace it.

User Avatar

You have a bad relay. Your blinkers run on a different relay than you hazards do.

User Avatar

if you mean: "why do hazard lights flash when brakes are on", then the answer is because vehicles are equipped with a hazard light relay that supercedes the brake lights. This way, slow moving vehicles can operate under hazard lighting.

User Avatar

Flasher unit (signal lights) on this car is part of the Hazard Light Module. It is located between the steering column and the radio underneath the dash. It is closer to the radio. The factory Hazard module on my car was colored green but im sure it can be any color. If you turn on your hazard lights you can feel the unit click. Once found you can apply upward pressure with your thumb to release it from its location allowing to to hang from its wired socket and making it easy to replace.

User Avatar

Hazard lights should be used if a vehicle is pulled over on the side of the road. If a vehicle is going slow when pulling something behind them, hazard lights should also be used.

User Avatar

Try replacing the hazard lights switch. 40 bucks at dealership for the part, require no tools to replace.

User Avatar

This bike does not come standard with hazard lights. There are many vendors that sell add on kits that can supply hazard lights. Two of the top web sites are jpcycles.com and denniskirk.com

User Avatar

Hazard lights are used on a vehicle in an emergency. The driver is supposed to turn the lights on the warn others that their car is experiencing some sort of problem.

User Avatar

Try checking & replacing turn signal flasher, which is usually located underdash by your left knee if your sitting in the drivers seat. Good Luck...

User Avatar

Blown fuses. Consult your owners' manual for their location.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.