0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
You have water coming into passenger side of your vauxhall combo?
common fault on corsa combo, it the passenger door seal fella.
How much to change a head gasket on a 1.2 l corsa?
pieces of rubber seal found inside the thermostat housing on my corsa 1.2 sxi (04) plate, where did the rubber seal or gasket come from?
Door weatherstripping on 2002 Volvo S80?
If you want to install door weatherstriiping on 2002 Volvo S80 you should try to follow this steps: Open the car door and inspect the existing door seal. Begin at one end and pinch the seal with your fingers and pull up. Find the anchor points for the old door seal and determine if it is glued or clipped or if screw fasteners hold it to the door frame. Use a razor to cut the seal away from the frame for glued applications, unscrew the fasteners for screw anchors or pull up on the seal with pliers where it clips into existing drilled holes in the door frame. Clean the door frame where the old door seal was attached. Clips that hold the new seal should be sanded lightly with Emery cloth. Door seals that use push clips should have holes that are clear of debris. Use a drill and bit to clean these holes. Clean the door frame down to the metal where the old door seal was laid if the old seal was glued to the frame. Stretch the new door seal around the door frame for a proper measurement. If the new door seal has push pins or slides that need to be mated with the holes or slides on the car door frame, then you must adjust the position of the new seal to match the anchor points on the frame. For glue-type door seals, you just need to cut and measure to the correct length. Secure the new car door seal to the car door frame. If you are screwing the new seal in place, use the existing anchor points to fasten the door seal to the door. For a seal using fasteners, push the new fasteners into the existing holes. Glued seals will require you to spread an even layer of glued along the outside of the door frame and then center the seal and press firmly to affix the door seal to the frame. Glue should be allowed to dry at least six hours before closing the door, preferably 24.
How do you stop the doors freezing closed on a vauxhall or opel tigra?
Try spraying the rubber door seal with a silicone lubricant spray, also spray the door frame where the rubber meets it. Do not wipe off, let it dry off naturally. Most car accessory shops would carry it.
How do I install a outer door seal or weather strip for a Jeep wrangler half door that has more clips than the corresponding holes than they are suppose to push into?
If the new door seal has more clips than is necessary to install it on a Jeep Wrangler, the seal can be trimmed with a scissors to fit the door. Another way to remedy this is to return the door strip to the store where purchased and get the smaller, half door seal.
How does a fridge door stay shut?
the door seal has a magnet strip in it
How can the drivers side floor get wet on a 2000 Honda accord?
Defective windshield seal? Defective door seal or door not adjusted properly?
What actors and actresses appeared in People of the Seal - 2009?
The cast of People of the Seal - 2009 includes: Aquilina Lestenkof
Why does your 98 Honda civic leak in the front passenger side when it rain?
Defective windshield seal? Door not aligned properly? Defective door seal?
When was Commitment - Seal album - created?
Commitment - Seal album - was created in 2009.
Why does water build up in rear driver's side door and on the floor in my 1996 Pontiac grand am?
The seal around your back door is not working properly. This is allowing the rain to seep in through the seal and run down the inside of the door.
Why are magnets used in refregeraters door?
To create an airtight seal.
