Firstly remove existing hose from charge cooler.Block off end of pipe(you may want to shorten pipe for neatness)attach short silicone hose connector(Samco or similar)to charge cooler,attach Dump valve to this,and re use vacumm take off from original d.v.
No you, need to have a turbo in order to fit a dump valve
These will not bolt up, there is a different floor pan design, with help from an engineer they may be able to make alterations to the seat rails to make it fit though. The 2001 Celica seats are very comfortable. I may recommend finding some GT4 ST205 seats if you can't get the 2001 celica seats to bolt in
erm... the club 1.6 8v is a petrol non turbo right?! to need a dump valve you need a turbo, a dump valve is there to release the pressure that the turbo builds up. you can always look for a fake dump valve kit around £180 mark i think
Yes it will
yes
yes it will.
The transmission from a 94 Celica GT will fit in a 91 Celica GT with minor modifications. This includes adjusting the shift linkage and mounting points.
it should fit. but make sure the trans lines up. be for you try it
yes
There is no point in doing that as the Fiat Bravo HGT has a Normally Aspirated engine ( no turbo)
The 1990 Celica door will be a direct bolt on to a 1992 Celica GT. Even the Coupe model doors were the same.
No the chassis of the 1993 Toyota Celica will have to be modified to fit it. The transmission required also uses a 4WD system which will have to be custom made for the Celica.