Every component of the car will possibly need disassembled and checked for water damage.
It's most likely the sending unit. have your mech check that for you.
I had a 1983 and a 87 some parts were interchangeable
If all do not work - check fuse in power distribution block under hood
could be just the spark plugs, start with that its only a few dollars to fix
You will need to remove the fan and check for debris in it.
I've bee told that the 1991 model doesn't have a cable it works off the speed sensor.
There is no speedometer cable on a 1990 Chrysler New Yorker. The speedometer is electically driven by a speed sensor mounted on the transmission. often the contacts are just corroded and some electrical cleaner will fix it right up. Other times the sender will have to be replaced. They are available from major Auto Parts stores like NAPA, or from the dealer.
To fix a fuel line on a 1993 Chrysler New Yorker, first ensure the vehicle is parked safely and the engine is cool. Locate the damaged section of the fuel line, then relieve fuel pressure by removing the fuel pump fuse and starting the engine until it stalls. Cut out the damaged section and replace it with a new fuel line, using appropriate fuel line clamps and ensuring all connections are secure. Finally, recheck for leaks before starting the engine.
On a 1989, the speedometer signal comes from the sensor in the housing where the passenger side axle shaft goes in the transmission.
It doesn't have a speedometer cable. The system is all electronic..It doesn't have a speedometer cable. The system is all electronic..
To fix the headlamp door system on a 1989 Chrysler New Yorker, start by checking the vacuum lines and connections, as this system relies on vacuum pressure to operate. Inspect the headlamp door actuator for any signs of damage or wear, and replace it if necessary. Additionally, ensure that the relay and associated electrical components are functioning properly. If the issue persists, consult the vehicle's service manual for specific diagnostic procedures and part specifications.
Not recommended. The water pump runs off of the timing belt, if the belt fails the valves can bend.