answersLogoWhite

0

What else can I help you with?

Related Questions

Why would the speedometer stop working after auto start was installed on a 94 Chevy pickup?

Someone knocked a wire loose.


What truck did Clint eastwood drive in every which way but loose?

1956 gmc 3200


Why no gas to engine in 89 Chevy pickup replaced fuel filter?

Bad fuel pump, fuel pump relay, blown fuse, or loose connections.


What are better snapbacks or fitted hats?

Fitted hats because the snap is always getting loose


97 Chevy pickup grinds when turning steering wheel not low on fluid. What could be wrong?

Air in the PS system, loose belt or a tired PS pump.


Chevy pickup hard to shift out of park?

I just had this problem with mine, and it was a loose nut on the linkage. There is also a brackett held on by the transmission pan bolts, they were loose too. After tightening all these up it shifts fine again now.


1991 chevy s10 pickup loose all power and not start driving down the road?

Sounds like the alternator has failed and you ran the vehicle until the battery was drained.


I installed new brake light switch on 1994 Chevy pickup truck but brake lights work now and then.?

Check for a loose connection Check for a loose fuse in the fuse box Check for an open wire in the brake light circuit


Should you put radiator cap on tight or loose on your 1996 Chevy S-10 pickup?

The cap should always be installed tight, that is the way the cooling system is designed to work.


How do you tighten a belt on a 1995 Chevy pickup?

The system should have an automatic belt tensioner. If the belt is loose the tensioner must be shot. The tensioner is available from your local auto parts store.


Forms as pieces of loose material get pressed or cemented together?

Sedimentary rocks form as pieces of loose material get pressed or cemented together. The process of forming sedimentary rocks is lithification.


What is pressed eyeshadow?

A pressed eyeshadow is basically a loose pigment taken out of it's container and "pressed" into a little eyeshadow pan. This is done because loose pigments can be hard to work with- since it is in "loose" form, it can be very messy and a lot of products tend to get wasted.