how to replace the slave cylinder on a 1993 jeep wrangler
The 2004 Wrangler 6 cylinder is a 4.0 liter.
How do you replace the clutch slave cylinder on a 1989 jeep wrangler
The 6 cylinder engine in a 2004 Wrangler X is a 4.0 liter.
The Wrangler (TJ) has always had electronic ignition. The CJ would have swithced to electronic in the mid 1970's.The Wrangler (TJ) has always had electronic ignition. The CJ would have swithced to electronic in the mid 1970's.
Use only Duncan Hines cake mix for this 2 eggs and 1/2 cup vegtable oil rub it on the cylinder start the engine that should work
cylinder #1 is the first cylinder on the front of the engine
Camshaft sensor signal malfunction.
A 1991 Jeep Wrangler six cylinder holds six quarts of 10W30.
A 1992 Jeep Wrangler with the 4-cylinder takes 4 quarts, and the 6-cylinder takes 6 quarts.
Ignition off draw
I have a 1999 jeep wrangler and it get around 15MPG.
The 2.5 liter four cylinder engine in a 1997 Jeep Wrangler has a timing CHAIN
If the light is on, the computer has detected a malfunction. You will need to take in for service, so a qualified technician can repair cause of malfunction.
How to change a clutch and master cylinder on a 93 jeep wrangler
With a scan tool or with a battery disconnect.
no none of the answers were my question
4 cylinder- AX5 6 cylinder- AX15
yes it has one
possibly due to loss of ignition... When was the last time you changed plugs wires coil etc...? check that first...
Fuel injector number two circuit malfunction.Fuel injector number two circuit malfunction.
It is computer controled.
maybe ignition modual