take the springs out
To repair the driver side door latch assembly on a 1992 Plymouth Sundance, first remove the door panel to access the latch mechanism. Inspect the latch for any broken components or misalignment; lubricate moving parts if necessary. If the latch is damaged, replace it with a new or used part, ensuring proper alignment with the locking mechanism. Reassemble the door panel and test the latch to confirm it opens smoothly from the outside with the key.
To remove the interior door panel on a 1990 Plymouth Sundance, start by disconnecting the negative battery cable for safety. Remove any screws securing the panel, typically found near the door handle, armrest, and bottom edge. Carefully pry off the panel using a trim tool or flathead screwdriver, being mindful of any clips that may still be holding it in place. Once loose, lift the panel upwards to detach it from the door frame and access the internals.
To fix a car door that is sprung due to a bent or damaged hinge, the best thing to do is replace the hinge. If the hinge is welded and not bolted to the vehicle, the entire door will have to be replaced.
1992-1995 Dodge, Chrysler, and Plymouth minivans.
first you take the fender off the front (only if its the front door) on the side your working on, once its off you will see the hinges and take the bolts off (make sure window is down door shut and that you have someone to hold the door up). all you have to do after that is take the door off by opening it or sliding it off.
Sprung is the past participle form of spring: If you sit in a chair with springs that have sprung, you'll have an uncomfortable seat!
Begin by removing the inside door panel on your 1997 Plymouth Grand Voyager. Remove the door lock linkage. Remove the door lock retaining bolts. The door lock will come out.
The door being open.
I doubt it very much. 2 door cars will fit both Plymouth and dodge 2 doors the 4- door will not fit a 2 door it is a taller winsheild
She knocked very gently on the door. Mr. Nutter sprang from his chair, opened the door, and asked her why she was late.
Go to this website. It will show how to remove the door panel.
The VIN on a 1993 Plymouth is at the lower left of the windshield and on the driver side door jamb.