Wiki User
∙ 9y agoYou should call an repairman +97145864033
Or visit website for best washing machine repair service near me
lary page
Wiki User
∙ 9y agoCall in a repair man.
If your clothing is coming out still-dripping wet, the spin cycle is not engaging. Try using a different setting on the washer. When you hear the spin cycle begin to engage, peek into the washer and see if the drum is actually spinning. DO NOT put your hand in the machine and try and start the drum spinning. If the drum does not spin up on its own, then you need repair on the washer. You might also be over-loading the drum. Have it looked at, but it is often an easy fix.
The water cut off device is stuck in the full position. -You don't say what kind of machine, or else I could tell you how to fix it.
What is wrong with your spin cycle? Most likely replacing the ring will not fix your problem, unless you are just referring to a noise/vibration problem.
A ceiling fan wobbles if it is unbalanced. You can fix it by taping or gluing a small weight to the blade opposite to the one that appears to be the lowest as it is spinning.
Sounds like a lever.
Get a new blower wheel and replace it. No sense spinning your wheels trying to fix it, simply replace it. A wheel should cost no more than 65.00 and it is a very simple change out.
This is a great video on how to take apart the washing machine. In reverse order, he shows you parts of a washing machine. Check out the instructions here: http://www.mindbites.com/lesson/425-fix-washing-machine
nope
If a wire comes loose or breaks, yeah, you might be able to fix it. The most common failure is in the drive transmission. It is a shop job with a few special tools to replace them, and the cost is fairly close to the cost of a new washing machine.
whirlpool stacker washer/dryer makes bumping noise when spinning out, checked for uneven load, not the problem, what next?
you fix it with tool and stuffyou don't break itmake sure you use it right
Well in the first place it depends what is wrong with it - YOU haven't told us that. - A washing machine is a very complicated machine and can have many problems -not even many handymen fully understand them. In your case, I would recommend calling an appliance technician.
To get a washing machine repaired, one could typically go to an appliance engineer for a repair. If one is not available, the washing machine may have a warranty on it to get it replaced. If neither of these solutions are possible, then a plumber may be able to fix the problem if it is a problem with water flow.
The procedure will differ depending on what's wrong, but here's an overview of common things that can go wrong and how to fix them: http://home.howstuffworks.com/how-to-repair-a-washing-machine.htm
If your washing machine is on the fritz give Chicago Air Conditioning, Heating and Appliance Repair a call, they might be able to fix it. They have a four out of five rating on Google. 866 625-9239
You throw it out and by a new one.
If your clothing is coming out still-dripping wet, the spin cycle is not engaging. Try using a different setting on the washer. When you hear the spin cycle begin to engage, peek into the washer and see if the drum is actually spinning. DO NOT put your hand in the machine and try and start the drum spinning. If the drum does not spin up on its own, then you need repair on the washer. You might also be over-loading the drum. Have it looked at, but it is often an easy fix.