There could be several reasons why your Maytag washing machine is not spinning. This could be due to a broken belt, a fault in the motor, a clogged drain pump, or an issue with the lid switch. It's best to consult a professional technician to diagnose and fix the problem.
The issue could be with the timer mechanism or a faulty switch that controls the cycle. It's best to disconnect power to the machine and have a professional technician inspect and repair it to ensure safety and proper functioning.
To stop your washing machine from moving, make sure it is level on the ground and all feet are properly adjusted. You can also place a rubber anti-vibration mat under the machine to reduce movement and noise. Additionally, avoid overloading the machine or using an unbalanced load during washing cycles.
Now not everyone know's who but I'm not quite sure either well u could look things up on ask.com or this website but it wont tell u i go to Google it takes mi to this website when i ask certain questions im not sure why?But im PRETTY sure u will figugre this answer out well if you don't i hope u will cause i might probaly figure this out if i do i will post it on here so u or people may know this answer to this question.!
A clunking noise in a Whirlpool washer can be caused by a variety of issues such as a broken drive belt, worn drum bearings, or a loose drum pulley. If the washer is not spinning all the way out, it could be due to an unbalanced load, a malfunctioning motor, or a faulty control board. It is recommended to have a professional technician diagnose and repair the specific issue.
Yes, it wont harm you, if you wash up right after then the pee wont get on you! If you have to pee then just go!
I buy a new one
May be a wigwag problem - one of the coils went bad. Not joking - google it- I had this problem.
The wig-wag or spin actuator or belt is faulty. -Simple problem for someone experienced in washing machines.
It could be the transmission or the belt. Many washing machines, while having different manufacturers, work on the same principle. For example, I owned a Kenmore machine for many years, and when I had the spin problem, I first checked the transmission. Perhaps the machine's transmission is kaput (broken), or maybe a belt is busted. Try looking at these two things first. Also, make sure that your washing machine is plugged in. You probably need a pump and motor kit
i know, but i wont tell you
The issue could be with the timer mechanism or a faulty switch that controls the cycle. It's best to disconnect power to the machine and have a professional technician inspect and repair it to ensure safety and proper functioning.
To stop your washing machine from moving, make sure it is level on the ground and all feet are properly adjusted. You can also place a rubber anti-vibration mat under the machine to reduce movement and noise. Additionally, avoid overloading the machine or using an unbalanced load during washing cycles.
If your washing machine does not spin, it could be several factors. Some older machines are belt driven, and it might be the belt that broke. More modern machines have transmissions in them that control the central agitator and the spinning of the drum. It could be possible that the transmission has died, or there is usually a plastic coupling-motor flange in the transmission that might have broken or worn out. If you hear a humming, or start to smell a burning odor, stop the washer and have it looked at by a service tech. Chances are if you can hear something, it is worth fixing. However, transmissions are not worth the price of replacing them.
its either the trans or case
Tell them they're cheap idiots and get your money back.
i wont to buy a lava wave machine
First check the feet to ensure that it is level. If it is level and still having this problem, it may be the springs that hold the inner tub in place that need replaced or repaired.