Honda Civic

How do you fix an oxygen sensor on a 2000 Honda civic?


Top Answer
User Avatar
Wiki User
2016-06-09 07:15:00
2016-06-09 07:15:00

The only thing you can do to them is change them.


Related Questions

On the exhaust system. There is more than one.

All O2 sensors are located somewhere on the exhaust system.

It is underneath the car, at the exhaust manifold where it comes off the engine...access it from the bottom

Check the OXYGEN SENSOR Do it yourself: $70.00 Professional: $220.00 Difficulty: Beginner

The crankshaft position sensor can be found on the bottom of the engine in a 2000 Honda Civic EX. It is next to the crankshaft itself.

It depends on the model. D16Y8 Honda Civic EX 1996-2000 D15Z Honda Civic HF 1996-2000 D15Y7 Honda Civic DX/LX/CX 1996-2000

No. The motors are different, the 2000 Honda Civic uses D16 motors and the 2001 Honda Civics use D16 Motors.

Where is the main relay in a 2000 honda civic ex

ummm depends how well u want the sensor 2 be... premium costs about 2000...but the 1 that is most used is the Advanced OS....which costs about 2500-3000

Possibley, the Clutch sensor, or the transmission is going.


2000 Honda Civic EX 0-60 in 8.5 secs.2000 Honda Civic Si 0-60 in 7.5 secs

Follow the intake manifold. Sometimes, there are oxygen sensors on the exhaust under the car.

How i reset the computer on Honda civic ex 2.000

need diagram to install 2000 Honda civic syder fog lights

To fix a ratio on a 2000 Honda Civic transmission, follow the procedure stipulated in the users manual.

yes it will every civic from 96 to 2000 will pretty much fit.

how tu install CD player in Honda civic 99

How do you adjust the kickdown cable on a Honda Civic 2000 ex

How do you change the front and rear brake pads on a 2000 Honda Civic Si?

The timing marks on a 2000 Honda Civic Ex Coupe are on the crank pulley. They are also on the cam.

Trouble code P0131 means: O2 Circuit Low Voltage (Bank 1, Sensor 1)

No the ckf and the ckp are not the same sensor for a 2000 Honda civic. The crank fluctuation sensor is behind the crank pulley and can be changed fairly easy with some mechanical knowhow when the timing belt is done. The crank position sensor is built into the distributor. To change this sensor you would have to rebuild the inside of the distributor or replace the entire distributor. Hope this answers your question.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.