Often times the brake switch located near and operated by the brake pedal needs to be adjusted. There is a locknut that needs to be loosened and then the whole switch is rotated clockwise (usually) to get it's pin to retract inwards so as to break the circuit. Normally, when the pedal moves away from the switch the pin is pushed out and an internal connection is made to light up the brake lihting circuit. If that does not happen,then the switch could be replaced. If a whole lot of turns are needed, unclip the wiring harness. There would normally be a proper set up procedure specific to the make and model and year. Find out what that is.Also worth looking at is 2 wires shorted together in the circuit. If that's the case you can spend a bit of time tracking it down.It would also tend to drain your battery fairly quickly.The brake lights use a lot of juice to light up a lot of filaments!Remeber this is by design kinda general.
yes, they do
There is a bushing that the brake light switch rest against when the brake pedal is not depressed. They are known to break. You can get a replacement bushing from any Honda dealer for around $5.00. Just tell them your brake lights stay on all the time and they will know what to give you.
the brake light switch on the brake pedal is bad and needs to be replaced. A $10.50 part at parts store.
Out of adjustment. Adjust the mounting of the switch so the brakes lights are off until you press the brake pedal.
Could be the brake light switch above the brake pedal.
Probably a brake light switch.
a bad or mis-adjusted brake switch.gmjim
In my experience, when brake lights remained on even after stopping and shutting off the car.....many times it was the brake stoplight switch, usually located on the brake pedal arm up above the pedal.
you need to clean the electric contacts on the rear lights, its just a earthing problem
You probably have a faulty brake light switch
1 of 3 reasons why, your head lights are on, your reflector lights are on ,or your brake sensor is broken
== ==