Was hoping this reference site could answer that question- apparently not
Disconnect it from the power source.
first peal the potAto and tAKE 9 volts battery fix to+ and_ take +one and fix with bulb now take _one and fix to the potato take one more wire and fix to other end pf the potato now join the wire to_one
Yes, but with a heavier gauge wire <<>> If the cord on an electric heater needs to be lengthened as a perminant feature then the whole cord should be replaced with a new cord of the same type and wire size. What this prevents is aquiring bad splice connections at the point the connection is made. Bad splice connections will create hot spots in the cable. If the lengthening of the cord is just a temporary fix, just use an extension cord. The extension cord should be the same wire size as the heater cord. Keep the extension cord under 20 feet in length.
if the wire experience a change in length (dx), the work(W) is simple equal to: W = F * dx, where F = mg if the wire din experience any lengthen effect, the W will equal to zero due to dx = 0.
u can pull it out until u see where its white amd cut the black part off
To fix a cable on an electric window on a 2004 Chevy Epica you need to first gain access to the wire by removing the door panel. From there, you can either fix or replace the cable.
what is the average repair cost to fix an electric window switch motor 2003 jeep
You can't. Buy a new one, sorry. :/
you can cut wire of battery for 2 hours. then you fix it and enter your correct code.
The only way is to follow the hot wire to the damaged area that is grounding and cut out that section or tap another hot wire and use it instead
I had same problem, it ended up being a broken wire that runs between the door and the body of the car inside a rubber cover. Easy fix too, remove the rubber sleeve, cut the wire, strip the ends of the two wires and use a butt connector to rejoin them.
Get a new wire
Pull the carpet back under where your feet are when driving, you will see the wires going to the seat the wires get worn from moisture and just pressure from your feet cut and splice in new section of wire. Chris
By calling the company that owns the cable. Im sure they will be willing to provide information instead of haaving to come out and fix it after someone cut through it
Simply drag one over to the electric, and they should fix it.
Solder the wire.
go to any electronic shop and buy a new one. if you have no money for that, well then, i don't know!