There is no fixing the actuator, replace it with a new one.
where is the defrost/floor door actuator on 2002 chevy trailblazer
Could be,a stuck open thermostat,low on coolant,plugged heater core,faulty temp blend door actuator,
how do you fix security switch on a 2002 oldsmobile alero
Temperature Actuator Replacement LHRemoval Procedure1.Remove the left instrument panel insulator (this is the carpeted cardboard piece above the brake pedal that connects to the knee bolster)2.Remove the knee bolster (this is the pad below the steering column)3.Remove the steering column filler (this is the metal piece behind the knee bolter, under the steering colum) (4 larger bolts, and I think 2 smaller ones)4.Disconnect the electrical connector from the temperature actuator.5.Remove the HVAC Con (HVAC Control) MiniFuse #27 from the IP electrical center.6.Remove the mounting bolts from the temperature actuator.7.Remove the temperature actuator.Installation Procedure1.Position the temperature actuator, then align the slots in the electric actuator driver to the flats on the temperature valve shaft.2.Slide the electric actuator driver onto the shaft, while aligning the actuator locating hole to the forward alignment pin on the HVAC module case. The actuator driver should completely seat onto the temperature valve shaft and the mounting holes should be flush with the mounting bosses on the HVAC module case.3.Install the mounting bolts to the temperature actuator.Tighten the temperature actuator bolts to 1.5 N·m (13 lb in).4.Connect the electrical connector to the temperature valve electric actuator.5.Install the knee bolster.6.Install the left instrument panel insulator.7.Install the HVAC Con (HVAC Control) MiniFuse #27 from the IP electrical center.Temperature Actuator Replacement RHRemoval Procedure1. Remove the right instrument panel insulator. (The carpeted cardboard piece below the glovebox)2. Remove the instrument panel compartment. (glovebox)3. Disconnect the electrical connector from the temperature actuator.4. Remove the HVAC Con (HVAC Control) MiniFuse #27 from the IP electrical center.5. Remove the bolts retaining the temperature actuator.6. Remove the temperature actuator.Installation Procedure1. Position the temperature actuator, then align the slots in the electric actuator driver to the flats on the temperature valve shaft.2. Slide the temperature actuator driver onto the shaft, while aligning the actuator locating holes to the forward alignment pin on the HVAC module case. The actuator driver should completely seat onto the temperature valve shaft and the mounting holes should be flush with the mounting bosses on the HVAC module case.3. Install the bolts to the temperature actuator. TightenTighten the temperature actuator bolts to 1.5 N·m (13 lb in).4. Connect the electrical connector to the temperature actuator.5. Install the instrument panel compartment.6. Install the right instrument panel insulator.7. Install the HVAC Con (HVAC Control) MiniFuse #27 from the IP electrical center.
No.
The ETC sensor on the 2002 Olds 3.5 engine is located at the right rear of engine, below the throttle body at the head not the block.
where is the crank sensor located on a 2002 Oldsmobile intrigue 3.5
where is the fuse and relay for the power windows on a 2002 Oldsmobile alero
2002 bravada oldsmobile
show location of camshaft position sensor for 2002 Oldsmobile bravada.
need to know were the blend door actuator is for a 2002 gmc yukon on the drivers side , dual climate controls, rear air and heat
I have a 2002 Oldsmobile bravada and we changed the oil today it took about 7-8 quarts.