0
Not sure what the question is referring to - but if my guess is correct, you might have a corroded power window switch on one of the doors. Often times, rain will get on these switches and cause the switch contacts to get "gummed up" or corroded over. Simple job to remove the switches (do them both) and clean them off really good with some isopropyl alcohol and a Q-tip. You can replace the moisture barrier with the stuff sold by Auto Zone in a small squeezy pack! Good luck!
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Engine oil capacity of a 2004 Chrysler sebring?
2004 CHRYSLER SEBRING COUPE = 4.6 Qts W/Filter 2004 CHRYSLER SEBRING SEDAN = 5 Qts W/Filter Hope This Helps.
What color is the hot wire in a power window in a 2004 Chrysler sebring?
The wires for the left front window are red/black for up and green/black for white. For the right front window, the wires for up are red/white and the wires for down are green.
Where is the fuel pump located on a 2004 Chrysler Sebring?
The fuel pump on a Chrysler Sebring is inside the fuel tank.
Will a 1999 Chrysler Sebring top fit a 2004?
No.
What does it cost to replace a carburetor on a 2004 Chrysler Sebring?
It would be very expensive considering that car doesn't have a carburetor.
Where is the fuse box in a 2004 Chrysler Sebring?
The 2004 Chrysler Sebring fuse box is located in the engine compartment. The fuse box will be on the drivers side behind the battery box.
Where is the starter fuse on a 2004 Chrysler Sebring?
The 2004 Chrysler Sebring starter fuse can be found in the fuse box. The location of the fuse can be found on the inside cover of the fuse box.
Does a 2004 Chrysler sebring 2.4 have an interference engine?
Yes.
Does a 2004 Chrysler Sebring have cv axles in front?
Yes
What type of oil is needed for a 2004 Chrysler Sebring?
5w30
Does a 2004 Chrysler Sebring have rear ball joints?
Yes
What kind of oil does a 2004 Chrysler Sebring take?
5w30
