Want this question answered?
the plastic becomes weak
On the plastic overflow bottle
The cap is on the plastic overflow bottle on the firewall.
Remove the bottom radiator hose. the fluid will run out. replace the hose and re fill the radiator at the top, through the radiator cap. run the engine until warm. check the overflow/expansion bottle attached to the radiator cap (The white plastic bottle). top up as required to the full level on the bottle.
You pour it into the plastic bottle on the left side of the engine compartment.
right side of engine,is a big plastic bottle,do not open when hot!
no, it's on the reservoir. Yes, the radiator "system" has a pressure-release cap located on the plastic coolant fill bottle. This bottle is an active part of the cooling system, and is where you add coolant to the system
You can do it either way. If you add it to the radiator, make sure you open it carefully when it is hot to prevent burns.
There is a white plastic bottle next to the radiator cap. This is where you put the water. there is a mark saying full . if you go beyond this by mistake it wont do any harm in my experience. the water is sucked from this into the radiator.
you get a plastic bottle
The reservoir for the radiator is actually the expansion bottle located on the nearside (passenger side) of the engine, close to the windscreen side of the engine compartment. It is a yellowish plastic bottle with a screw cap, it has max and min water levels embossed on the side.
A plastic bottle shape.