0
When my pt cruiser went into limp mode it was because it needed a new camshaft position senor. The engine was limited to 2500 RPM. The sensor is on the top diver's side of the engine. It has two 10 mm bolts and a plug attached to it. After replacing the sensor I cleared the trouble code using an OBD II reader. If you do not have this then disconnecting the battery for a couple of minutes will work. If the sensor was the problem then the car should run normal. The camshaft position sensor was $40.00 from Checkers.
The cause of the code will need repaired to get it out of limp in.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you get a 2003 Chrysler pt cruiser out of limp mode?
You have to fix the problem that caused the trouble codes that put it in limp mode.
What is the size of rear brake shoes on 2003 PT Cruiser?
The 2003 PT cruiser uses brake shoes with the part number: 5018209AA
Does the 2003 PT Cruiser have the LATCH system?
yes it does
What is 2003 Chrysler pt cruiser spark plug wires firing order?
What is the firing order of a 2003 or cruiser
What is the turning radius of a Chrysler PT Cruiser?
According to Cars.com, the turning radius for a 2003 Chrysler PT Cruiser is 18.3 feet.
What is coolant capacity for 2003 PT Cruiser?
7.4 quarts
How do you reset automatic shutdown on a pt cruiser 2003?
A Chrysler PT Cruiser does not have a reset. The automatic shutdown is a computer controlled relay.
When to change timing belt on 2003 PT Cruiser?
80,000 miles
Does 2003 pt cruiser fuel tank have a drain plug?
NoNo
What is curb weight of 2003 PT Cruiser turbo?
3108 lbs.
Where is the distributor cap on a 2003 Chrysler pt cruiser?
It does not have a distributor cap.
Does a 2003 Chrysler PT Cruiser have a zero tolerance engine?
Yes.
