0
How do you get a trouble code up on a 1999 mercury villager when battery was dead and it will not start?
Wiki User
∙ 11y ago
If the battery was dead or disconnected all trouble codes will be erased.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What would cause a 1998 Mercury Villager to start only with a jump?
Dead battery? Battery cables in need of cleaning or replacement?
Why won't a 1995 Mercury Villager start when the temperature is below 28 degrees?
I had this problem and it was my battery,but could also be in need of antifreeze.
Mercury villager makes a clicking sound when trying to start It won't start and its not the starter. I had it checked.?
A clicking sound when you try to start the car is a dead battery. It may be that the alternator is not charging it properly.
Where is the starter relay located on a 2001 mercury villager sport with a 3.3L automatic?
start inhibitor relay located next to battery in fuse/relay compartment
How do you hot wire a 1997 mercury villager van?
This is not possible on a modern vehicle like the Villager.
Where can you get a vacuum hose routing on a 2000 mercury villager?
I would start by purchasing a repair manual.
What happen when the distributor start start to fail on 2000 mercury villager?
The car doesn't run right, that's what happens.
How do you disable the Factory Alarm on a 2000 Mercury Villager?
To disable the factory alarm on a 2000 Mercury Villager, put the key in the ignition and turn it halfway. Let it stay in the spot for 10 minutes and start the car.
Why would a 1993 Mercury Villager run fine one day and the next day not start but the engine turns over and the automatic set belts will stay in the closed position when the door is opened?
battery low
Why is there no power steering in my mercury villager at start up in cold weather?
There is no power steering in a Mercury Villager at start up in cold weather due to a failing pump or low fluid. Fluid becomes much thicker in cold weather and is much harder to pump.
Why woudn't my Mercury Sable start?
your battery was dead.
How do you start a Mercury Villager with a bad ignition switch?
You don't. The ignition is required to start the car. If it fails you need a new ignition switch.
