You have to go to the front of the wheel wells where there will be 5 bolts on a cover (You will see these in front of the wheels). Take these off; I believe it is somewhere around the #8 metric sized screw. Then once this is off, you will look up the fender where the fender connects to the bumper; there will be three screws here that you will have to remove. (These are #10 I believe). Do this to both sides, then open your hood, and you should see two bolts (Each one close to headlight) that are bolted into the frame. These are bigger bolts and are brackets for the Chevy symbol part. Remove these two bolts and pop the bumper off. It sounds confusing, but it should only take 30 min to an hour tops.
Hope this helps.
I am not entirely sure about the 2004, but in a 2001 Civic DX it is located behind the front bumper on the driver's side. You have to take the bumper off to get at it.
you would have to change the bumper and fenders on your sunfire to get the hood to fit but to start off u would have to change the front bumper clip to interchange bumpers
Reach behind the bumper of the 99 Cavalier. There are two nuts that hold the turn signal assembly in. Remove the nuts to take the assembly off and replace it.
The horn is on the left side under the corner of the bumper. If you take the bumper off you will know it when you see it.
check under the bumper. you might have to take some paneling off to get at it.
taking off the front bumper ... the only way to do that job like an expert.
remove laguna bumper
The 1998 Volvo front bumper is held in place with eight retaining bolts. Remove the retaining bolts and the front bumper will come off. Reverse the process to install your new front bumper.
start by taking off the driver side front bumper. its located right in front of the driver side wheel the rest should be easy.
The Toyota Corolla front bumper is held in place with eight retaining bolts. Remove the retaining bolts and the bumper will come off.
The front bumper of a 2000 Honda Civic is held on by several mounting screws. First remove all the screws, then gently pull the bumper off the remaining mounting clips.
how do you screw off front bumper to a land rover discovery 2001