answersLogoWhite

0

Make sure antifreeze level is not low. And also "bleed" air from the cooling system. Look for bleeders where water hoses enter the engine. (might be one right on the thermostat housing).

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

Where is the temperature sender located for the temperature gauge on a 1990 Chevy lumina?

1990 Chevrolet Lumina temperature sender is located on the back side of the thermostat housing. The sender has a wire that goes to the temperature gauge.


What make a 1990 Chevy Lumina Car cutoff?

what make a 1990 Chevy. Lumina Car cut off when make a complete stop.


How do you change a turn signal on a 1991 Chevy Lumina?

how can i change the turn singal on a 1990 Chevy lumina


How do you unlock a 1990 Chevy Lumina?

with a key


What year did Chevy Lumina come out?

1990


Is there a fuel reset button on a 1990 Chevy Lumina?

No.


How do you fix a stripped bolt on a 1990 Chevy lumina van thermostat housing?

You will probably have to re-thread unless you can get a SLIGHTLY over sized bolt to thread and seal


Where is the fuel filter located on a 1990 Chevy lumina?

On my Chevy lumina it is located right by the gas take on the right side of the car.


Why wouldn't windshield wipers work on a 1990 Chevy Luminum?

If the windshield wipers are not working on a 1990 Chevy Lumina, the problem could be with the wiper motor, the wiper motor relay, or a fuse. The least expensive fix to this problem will be replacing the fuse if it is blown.


What engines fit in a 1990 Chevy Lumina?

The 194 3.1 only


Does a 1990 Chevy lumina 6cyl have a timing belt or chain?

The 1990 has a chain. The 1991 has a belt.


Where are the motor mounts located on a 1990 Chevy lumina 3.1 liter?

There are four motor mounts located on a 1990 Chevy Lumina. Two on either side of the engine. One the rear and one in front of the engine.