while key is off hold down both arrow buttons on your trip computer,while holding buttons turn key on and reset should flash on the dash screen release buttons.press mode once and the service symbol indicating k's will come on flashing,hold both arrow buttons again and the flashing will stop and your done turn key off and check. did this today so it works!!!!!!
Holden VT Commodore was created in 1997.
turn signal located on VT commodore
how much to get brake pads and rotors replaced on a holden vt commodore
1.5mm
Passenger side kick panel
Go to the following link: http://www.ellery.com.au/pdf/Update%20EP.C107.pdf good luck Rod
Replacing a head gasket on a VT Commodore instructions can be found in a manual. Manuals can be bought at most auto parts retailers or in book stores.
The flasher unit relay location on a 1997 VT Commodore is under the steering column. The door has to be opened to reach the relay.
Commodore front and rear doors fit 6" speakers
To fix the door handle of a VT Commodore, remove the hardware from the door and loosen the knob. Remove the turn post and tighten all mechanical parts.
I found this whilst looking for an answer myself ;-) (don't know if this site allows links so just ad http before the : ) ://forums.justcommodores.com.au/vt-vx-holden-commodore-1997-2002/83178-where-vt-sump-plug.html
Undo the transmission pan.