Undo the transmission pan.
1.5mm
Yep it should just bolt straight in
you can buy a car diagnostic tool to clear the fault data, and a website is a good choice, allobd2.com
Broken off the door or from main body? Main body- Prefabricate. Door- replace door.
mounted on the floor tunel below the radio, take side panels off 2 screws each, undo the 4 nuts on the ecu, unplug etc, pull it out.
Down the dip stick tube
Holden VT Commodore was created in 1997.
check transmission fluid level bad transmission?
turn signal located on VT commodore
how much to get brake pads and rotors replaced on a holden vt commodore
1.5mm
Passenger side kick panel
Replacing a head gasket on a VT Commodore instructions can be found in a manual. Manuals can be bought at most auto parts retailers or in book stores.
The flasher unit relay location on a 1997 VT Commodore is under the steering column. The door has to be opened to reach the relay.
Commodore front and rear doors fit 6" speakers
To fix the door handle of a VT Commodore, remove the hardware from the door and loosen the knob. Remove the turn post and tighten all mechanical parts.
I found this whilst looking for an answer myself ;-) (don't know if this site allows links so just ad http before the : ) ://forums.justcommodores.com.au/vt-vx-holden-commodore-1997-2002/83178-where-vt-sump-plug.html