0
How do you get stroke to bat by putting oil and hammering to bat?
Wiki User
∙ 11y ago
if you put any oil except carosene oil on the middle part of your bat and then knock the bat by net practice or by putting the hard ball in the sox and knock it on your bat forcefully
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Does oil prevent water evaporation?
Oil evaporates very slowly. Oil doesn't mix with water, and most oils are less dense than water. So oil floats on top of water, and usually makes a very thin layer, covering all the water you have, or else it spreads out until the oil layer is just one or two molecules thick and you run out of oil. When the oil is covering the water, it prevents water molecules from evaporating, just like putting a lid on a jar.
How does a diesel engine get its energy?
A diesel engine heats a volatile fuel or oil, and mixes it with hot compressed air, causing it to rapidly combust (explode). Whereas a gasoline engine uses much more flammable petroleum distillates, a diesel engine can use many types of refined oils, such as peanut oil or mineral oil. The fuel is sprayed into a heated combustion chamber (cylinder) where air in the chamber has been trapped and compressed by a moving piston, leading to compressive heating of the air. The oil explodes, and it forces the cylinder back in the opposite direction (the power stroke, part of a measured cyclic motion). On the following stroke of the cylinder, the waste gases (mostly water and CO2) are forced out through a valve opening, and the cylinder is ready for more fuel.
What is oil energy?
Oil is a thick, black, gooey liquid also called petroleum. It's found way down in the ground, usually between layers of rock. To get oil out, a well is dug. Digging a well is like putting a straw into a can of pop. The oil is then pumped out of the ground, just like when you suck pop up the straw. Oil is carried in pipelines and large tanker ships. A refinery changes the oil into products like gasoline, jet fuel and diesel fuel. It's also burned in factories and power plants to make electricity. The oil is burned, which produces gases that turn a turbine to create electricity.The energy in oil is ancient sunlight trapped by organisms that lived in the past.
Which oil was used in oil drop experiment?
clock oil
How does oil become energy?
Oil doesn't really become energy. Like all substances, oil molecules have energy. When oil is reacted with oxygen and heat it burns. This is when oil releases much of its energy.
Would putting 15W40 oil in a 4 stroke 50cc moped damage it?
probably not but 10W40 is recommended
What would happen if you just put gasoline in the 2 stroke engine?
By putting only gasoline in a two stroke engine you can destroy it. A two stroke engine requires oil to be mixed into the gasoline to keep the moving parts lubricated. When you do not have that oil there it will not lubricate correctly and therefore scar and break the moving parts on the inside.
Can you run 4 stroke oil in a 2 stroke dirt bike motor?
There is no difference in 4 stroke and 2 stroke oil, except that 2 stroke uses non-detergent oil. 2 stroke oil is actually 30 weight non-detergent (30wt ND) oil. Oil with detergents will leave deposits in 2 stroke cylinders, and is not recommended.
What oil is faster 2 stroke or 4 stroke?
Oil is a lubricant. 2 stroke oil is designed to be mixed with gasoline and in that form it lubricates the engine. 4 stroke oil lubricates the engine but is not burned as 2 stroke oil is. This has nothing to do with speed. So, the answer to your question is neither is faster as they are just lubricants.
How to tell if a motor is 2 stroke or 4 stroke?
if your scooter has a engine oil dip stick then it is a four stroke. if it has a oil tank that you have to put oil in then it is 2 stroke.
Is the 6.0 Briggs and Stratton engine a four-stroke or two-stroke?
The best way to know if an engine is 2-stroke or 4-stroke, is to look for an oil spout. If the engine has an oil spout where oil has to be poured into, it is a 4-stroke. If the engine has no oil spout and the oil has to be added to the fuel, then it is a 2-stroke.
What kind of motor oil in a KX 125?
i use motul fully synthetic factory line 2 stroke oil in my kx 125.putting 25 ml to every litre.
What happens if you put gas in engine oil of ATV?
Putting gas into the oil of a 4-stroke ATV, and running it can cause damage if oil is diluted enough. Gas is not a lubricant and bearing/cylinder wall damage can occur. drain the oil and refill with clean oil.
What kind of oil do you put in a 4 stroke pit bike?
4 stroke oil
Gas oil mixture for 7.5 mercury?
It depends if it is a 2 stroke or a 4 stroke. A 2 stroke engine, you mix the gas and oil. A 4 stroke engine, there are separate tanks for the oil and gas.
Can you put 2 stroke oil in a 4 stroke lawnmower?
No - it is formulated very differently. The crankcase of a four stroke engine needs conventional engine oil. DO NOT use two stroke oil in the crankcase.
What will happen if 4 stroke oil is put into a car?
Nothing will happen. The oil that is required for all automobiles today is 4 stroke oil. So you are using 4 stroke oil anytime you change the oil.
