On the 4.3L V6 the distributor is located in the back of the engine, in the middle. Just follow the spark plug wires and they will lead you to it.
They are lined up like this on my 1995 Chevy blazer 4.3 L, V6 1,6,5,4,3,2
GAP AT .045 (IN THOUSANDTH OF AN INCH)
Should be along the frame under drivers seat.
Apparently it's less difficult when the car is on hoist.
The computer is located under the hood on the drivers side inner fender,
see if you are getting spark in your wires. or check for cracks and damage.
Left side (drivers side) of transmission.
A 1995 blazer does not have a crank sensor. SORRY
There are several things that can cause your 1995 Chevrolet Blazer to shake when accelerating. Bad spark plugs and spark plug wires can cause the vehicle to shake. Tuning up the engine may eliminate the problem.
The 1995 Blazer was rated at 5000lbs towing capacity.
Could be in need of a tune up consisting of replacing spark plugs, spark plug wires, distributor cap, rotor, air and fuel filters.
if its a cpi it would be in the the middle of the intake as part of a injector assembly on a 4.3L
The engine needs fuel, compression and spark to run. You are missing one of those, probably spark.
Where is the idle speed motor located at on a 1995 chevy blazer?
where is the fuel shut off swith on a 1995 Chevy s -10 blazer at
I beleve it is stamped right on the exaust manafold.. on the drivers side
Yes it will fit.
Being a Blazer it probably has the 4.3L V6.
Original manufacturer's tire size for a 1995 Chevy Blazer are P205/75R15 97S.