Cars & Vehicles
Clutches and Flywheels
Chevy Blazer
Chevy Blazer S-10

How do you get the fan off of a 1996 Chevy Blazer?

313233

Top Answer
User Avatar
Wiki User
2005-11-02 04:50:18
2005-11-02 04:50:18

REMOVE THE SINGLE DRIVE BELT, THEN REMOVE THE 4 MOUNTING BOLTS BETWEEN THE FAN AND THE BELT PULLEY. THE FAN MIGHT NEED TO BE WIGGLED OFF

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

There is no "kill switch" on that Chevy Blazer.

User Avatar

HOW TO GET A PULLEY OFF A 1998 CHEVY BLAZER

User Avatar

i don't believe blazers have fuel shut-offs, Jason

User Avatar

No thay will not. Car and truck wheels will not interchange.

User Avatar

where is the fuel shut off swith on a 1995 Chevy s -10 blazer at

User Avatar

how to take off the clutch fan in 96 blazer,trying to change water pump?

User Avatar

The blower speed switch on the dash and the plastic electrical plug that plugs into it may have melted down.

User Avatar

I need a diagram for the 1991 Chevy blazer to see where the 3 hoses go to coming off the transfer case.

User Avatar

Assuming this is the 4.3 L engine, 60 to 66 psi with fuel pump running, engine off.

User Avatar

Hey guys, I trying to take off a fan clutch on my 2003 chev blazer and want to know if I have to remove the radiator to do it.

User Avatar

Start the engine and drive it if possible and get it hot. Then open the hood and watch the fan turning, then turn the engine off and the fan should only turn about 2 times at the most after engine is HOT and then turned off. If it free spins several times then the fan clutch is bad. Replace clutch.

User Avatar

we are trying to find regular factory wheels that fit the lug pattern off of a 1997 Chevy blazer s-10 2 wheel drive

User Avatar

If the windshield wipers won't turn off on a 2000 Chevy Blazer, check the wiper relay switch. This is usually located in the engine compartment fuse box on top of the battery.

User Avatar

The switch or wiring has an intermittent connection. Try shaking the switch knob to see if the fan turns on and off. If it does then the switch is bad.

User Avatar

Do a valve job. This is more complicated than it sounds, you might be better off sending the head to your local machine shop for the valve job.

User Avatar

Remove the calipers and the disk will pull right off

User Avatar

Blazer does not take off like it should. sluggih slow take off then after it gets going it does wee.

User Avatar

Make sure it's topped off with 80 weight gear oil. But to answer your question, you diagnose the noise it's making to decide what is wrong with it.

User Avatar

Drain the coolant, pull off the top half of the fan shroud take the fan off of the pulley, remove the belt take the coolant hoses off of the pump and take out the four bolts that hold on the pump.

User Avatar

i need the firing ordere for 4.0 BMW


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.