Go to jetboatperformance.com. They have exploded diagrams of various pumps. You'll see the inspection cap that you can pull off and check for debris. Be carefull about pulling the cap if the water level is higher than the cap level......you'll sink.
A free jet boat.
What to do when impeller is stuck on jet ski
An impeller is used in many devices, such as a washing machine and water jet. An impeller is used to control the pressure and flow of water. It is found inside of a tube or a conduit, an impeller is a type of rotor.
Impeller jet propulsion.
There are different kinds of jet pumps but some of the main components are motor, discharge, jet assembly, lift, suction, nozzle, control value, impeller, and venturi.
chinese boat in china
a jet ski is not considered a boat in most places. It is a PWC (Personal watercraft). If you compare a boat to a car and jet ski Would compare to a motorcycle. Also jet skis have different laws Than boats.
It sounds as if you may have an impeller or driveshaft issue. If the impeller, or the impeller housing is badly worn, the craft will loose power due to excessive tolerance between the two parts. This is very common when used in sandy bottom, shallow water conditions, as the sand picked up by the rotating impeller wears away at both the impeller, and the housing. Also, in the case of little, or no service maintenance, the driveshaft splines may be severely worn, due to no grease, at the coupler or the impeller end, causing slippage.
It is considered a vessel( boat ).
yes
30 knots
1954