***CAUTION***The halogen bulb contains gas under pressure. The bulb may shatter if the gas envelope is scratched or if the bulb is dropped. Handle the bulb carefully. Grasp the bulb only by its base. Avoid touching the glass envelope. è The headlamp bulb should not be removed from the headlamp until just before a replacement bulb is installed. Removing the bulb for an extended period of time may affect headlamp bulb performance. Contaminants may enter the headlamp where they can settle on the lens and reflector. Never turn on the headlamps with the bulb removed from the headlamp. Headlights Removal & Installation 1. Raise and support the hood. 2. Raise the headlamp retainers by pushing rearward and pulling up. 3. If equipped, rotate the headlamp bulb protective counterclockwise and remove. 4. Disconnect the headlamp bulb electrical connector. 5. Remove the headlamp assembly. 6. Rotate headlamp bulb retainer counterclockwise and remove. 7. Remove the headlamp bulb by pulling it straight out with a gentle up-and-down rocking motion. ***WARNING*** Do not touch the glass bulb with your fingers. Oil from your fingers can severely shorten the life of the bulb. If necessary, wipe off any dirt or oil from the bulb with rubbing alcohol before completing installation. To Install; 8. Install a new bulb into the headlamp assembly. 9. Install the headlamp bulb retainer and turn it clockwise to engage the retaining tabs. 10. Attach the bulb electrical connector. 11. If equipped, install the headlamp bulb protective cover. 12. Install the headlamp assembly. è Be sure the headlamp assembly is positioned correctly with the alignment pins inserted into the proper holes and onto the ribs of the reinforcement. 13. Engage the retainers by gently pushing down. 14. Turn the lights on and check the bulb operation.
fold the mirror back and you will see a screw to remove it is a torx type screw on my Expy
I found the basic answer here on Wiki Answers, but after actually doing the work and taking some photos, I created a website that you really help. http://www.bobspchelp.com/help/auto/Ford/Expedition/2003/TailLightBulbs.htm
The 2003 Ford Expedition has a V8 engine.
The 2003 Ford Expedition has 16 valves.
the 2003 expedition does have cabin air filter
According to the 2005 Ford Expedition Owner Guide : Low beam headlamp ( # 9006 bulb ) High beam headlamp ( # 9005 bulb )
On a 2003 Ford Expedition : There is an ABS warning light to the left and slightly lower than the " E " on the fuel gauge , which you should be able to see when the ignition key is turned to the RUN position , just before starting the vehicle ( to prove that the bulb still works ) so it looks like a 2003 Ford Expedition does have an Anti-lock Brake System
The 2003 Ford Expedition is a gas-powered vehicle.
The 2003 Ford Expedition has a 4-speed automatic.
How do you replace a radiator on 2003 ford expedition?
According to the 2004 Ford Expedition Owner Guide : Low beam headlights take ( # 9006 bulb ) High beam headlights take ( # 9005 bulb )
The 2003 Ford Expedition has a 19.1 degrees angle of departure.