you can't do this. to get single phase from 3 phase you must disconnect 2 of the phases and use one of them as a neutral...b.
I'm not sure what your question means as a single phase supply is normally one of the phases and the return/neutral, not all 3 phases converted to one, plus return.
Single phase or three phase? 120/208 would be measured hot to ground for 120 and hot to hot (phase to phase) for the 208 reading. Any hot to ground will read 120 and any two phases together will read 208.
trigonometry, the phases are 120 degrees apart from each other. 1.732 gives you the potential difference between the two phases
There are three phases of drug effects. These three phases are the administration phase, active phase, and the metabolism phase.
If the primary and the secondary windings of the three phase transformer are connected in delta, you cannot get a healthy neutral from it but why bother? You simply drive a rod into earth and use it as a neutral. Alternatively either the primary or the secondary windings must be connected as star and you use the common point as neutral.
residential wiring are called single phase because the 2 phases coming in are one is neutral and the other is line.the neutral has a potential zero with ground and it is to provide a closed path for the current to flow through..the line is having a potential of 230V with the ground and a line together with a neutral is called a phase
A single substance has one phase.
I'm not sure what your question means as a single phase supply is normally one of the phases and the return/neutral, not all 3 phases converted to one, plus return.
In a three phase motor each leg (3 phases) in the down cycle alternating at 1/60 per second servers as a neutral, you are only required to ground (green) the frame of the motor for safety. This is similar In a single phase motor wired for 240v (2 phases) the same thing happens and you are only required to ground (green) the frame of the motor for safety. From: Ken F
Phase converters are mostly used to convert single phase electricity into multiple phases or to convert multiple phases into one. They are usually installed to provide three phase electricity where an individual may not get it otherwise.
240, single phase for houses208 3 phase for comerical property, can be single phase.480 volt for industrial property or 660 volts,all 60 HzUSA calls it single phase but there is actually 2 hot leads coming into the house with a natural and a ground.It is actually two 120 volt 'hots' which are 180° out of phase from each other. Voltage between either of these and ground will be 120 V. Voltage between the two hots is 240 volts. It is single phase because it is pulled off one of the phases from 3-phase, then a center tapped transformer gives the two 'opposite phases' (ground/neutral is off the center tap)In Vietnam we have 440 volts, 3 phase, 50 Hz on the poles.They bring in one hot wire and one ground. I call this single phase,It equals 220 volts in your house.
You cannot obtain a three-phase supply from a single-phase system without using some sort of rotary converter.
Phase converters are mostly used to convert single phase electricity into multiple phases or to convert multiple phases into one. They are usually installed to provide three phase electricity where an individual may not get it otherwise.
Single phase or three phase? 120/208 would be measured hot to ground for 120 and hot to hot (phase to phase) for the 208 reading. Any hot to ground will read 120 and any two phases together will read 208.
A single-phase supply needs two wires to allow the current to circulate.
the term ''homo" and "geneous" mean ''single" and "phase" respectively, hence,the name homogeneous indicates the single phase so,there are just one phase in homogeneous.
A rotary phase converter is commonly used to convert a single phase electrical power source to three phases. This allows you to use three phases instead of one.