I have not really mastered it myself, but basically one method is to make the entire inlet a misc body and model it hollow.
the other method I am working on is to make an object the shape of the inside of the inlet throat, make it transparent and place it inside the intake shroud.
The same as you make hollow wheel wells.
Similar methods are used for gun ports
you can use plane maker, it comes with x plane, and it is easy to use
Hawker Sydley Boing. BAA.
Not yet unless you download audacity clips to your cellphone or portable device.
High Intakes of Polished rice
AEM currently makes all Mopar intakes and relabels them as Mopar.
how many time UK university intakes
high intakes of meat and low intakes of fish
If you check the RPM ranges on both you will see where they perform well. The dual plane intakes tend to idle better and run better at lower RPM's which is where most people need them to run well. The single plane intakes are hard to get to idle well and don't really start performing well until the RPM's are higher. For the most part they will shine mainly at the race track where you don't care much about fuel savings or having it idle well. I would be skepticle of running a single plane even on a stroker motor unless it has been built with a cam for high RPM's which isn't a very desireable traight in an off road vehicle.
It's actually simpler than it sounds. There's a great article on TruckChamp.com's Air Intakes Learning Center called The Non-Gearhead's Guide to Air Intakes. It explains what it is, how it works, which is the best for your car, etc.
100
One can find a plane for woodworking from retails like eBay, Fine Furniture Maker, Antiq Buyer, Teds Woodworking, Amazon, Wood Craft and Fine Wood Working.
high intakes of meat and low intakes of fish