First you remove the trim around the cluster, then remove the cluster. There should be a cable going to the speedometer. Remove it by turning it counter clockwise. It feeds through the fire wall. You have to pull it out from the inside of the car, the new one needs fed in from the inside of the car out so watch where it is coming from. Then go around the car to the passenger side and under the hood, plug it in to the transmission. If it then doesn't work, then it may be your cluster. Toby Styles
Yes, the 1988 and 1989 Honda Prelude has a VSS that is a cable sending unit that connects to the gauge cluster in the dash.
The 1989 Honda Prelude had 4x100mm offset. The 1989 Nissan 240sx has a 4x114.3mm offset...so, it will not fit.
How do i take the fuel filter off my honda prelude si 1989
I have a 1989 prelude si and im pretty sure there 15s
The starter on the 1989 Honda Prelude is located on the left side of the engine. It is under the radiator hose that is at the rear of the radiator.
Please reask question: Where are the VALVES ON A 1989 HONDA? How many VALVES ON A 1989 HONDA? How do I adjust the VALVES ON A 1989 HONDA?
No, they are different.
None of the dashboard lights work on my 1988 Prelude. Why?
135
The 1989 Honda Prelude Si has a top speed of approximately 130 mph (209 km/h). This performance is supported by its 2.0-liter engine and sporty design, which combines agility with a responsive driving experience. However, actual speeds may vary based on factors such as vehicle condition and modifications.
The fuel pump on a 1989 Honda Prelude is located in the fuel tank. Being close to the tank allows it to pump gas more readily to the engine.
buy a hanes book