0
with your foot !
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What does the brake pedal assembly uses a mechanical lever for?
Increase the driver's force on the brake pedal applied to the master cylinder
Why does mower brake pedal shake?
your drive belt is streached or bad tension springs.
To dry wet brakes what should you do what?
you should gently press the brake pedal and gently press the gas pedal, the increase friction will dry the brakes.....
Where is the switch under the brake pedal you cant find it?
It is above the brake pedal not under it. Follow the brake pedal bracket all the way up and you will see the brake pedal switch.
Where is the brake light switch on a 93 Dakota?
Just above the brake pedal, on the mounting bracket that the pedal pivots on.Just above the brake pedal, on the mounting bracket that the pedal pivots on.
Where is the Emergency brake pedal on a 1966 Thunderbird?
to the left of the brake pedal
How do you brake down the number 32?
Take your foot off the gas and move it to the pedal on its side - the brake pedal.Take your foot off the gas and move it to the pedal on its side - the brake pedal.Take your foot off the gas and move it to the pedal on its side - the brake pedal.Take your foot off the gas and move it to the pedal on its side - the brake pedal.
What is meant by brake pedal pads?
It would be the rubber pad that sits on your brake pedal. Unless they were referring to brake pads, which are the pads which enables your vehicle to stop by pressing the brake pedal.
Where is the brake light switch on a 1997 chrysler sebring?
On the brake pedal bracket under the dash.On the brake pedal bracket under the dash.
How do you adjust parking brake on Ford Taurus?
# 1 Release the parking brake pedal to make sure it is disengaged. Put your Ford Taurus in "N" for neutral. # Step2 Raise your Ford Taurus rear wheels in the air using your jack and support the rear wheels with the jack stands. # Step3 Get underneath the vehicle and locate the parking brake cables. There is a cable coming from each rear wheel and meet in the middle with an adjuster nut. # Step4 Use the cable tension gauge 021-00018 or another tension gauge to measure the parking brake adjuster nut against the rear parking brake cable adjuster. Follow your tension gauge instructions to measure 18 to 26 pounds of tension for your 1996 year Ford Taurus and 34 to 46 pounds of tension for your years 1997 to 1998 Ford Taurus. # Step5 Press in on the parking brake foot pedal to the ground and then release the parking brake pedal. # Step6 Verify the rear wheels spin freely when the parking brake pedal is fully released. # Step7 Lower your Ford Taurus using the jack and remove the jack stands from the rear wheels.
What causes the brake lights to stay lit after the brake pedal is released?
manualy lift brake pedal to see if they go out. if so check spring at pedal
Where is the cruise control brake pedal switch on a 2002 Mercury villager?
On the brake pedal.
