You need two hot legs of 110 volts to make 220. While each led is 110 volts to neutral, between the two hot legs you have 220v. You should have two different hot legs of 110, a neutral and a ground to meet code now a days.
No, it is more difficult than installing a new plug. You cannot reuse the wire, it must be a dedicated circuit, you will need a new outlet, and you will need a new breaker. Install a new plug.
Not advisible.
how to install glow plug on ford f350 l997
no
Yes, but you need a converter that changes 220 to 110, if you plug it into a 110 plug. Of course, if you plug it into a 220 outlet you don't need a converter, but in either case you will need a plug adapter.
Yes, a 220 volt appliance can be installed in your home.
The whole of Europe, including the UK, uses the same voltage for mains electricity, 220 V 50 Hz. But the plugs and sockets are different in different countries. You will need to either change the plug or get a plug adaptor.
15mm
Yes, as long as the plug and receptacle match in pin configurations, it can be done.
Yes, as long as the plug and receptacle match in pin configurations, it can be done.
A 220 volt treadmill will not run on 110 volt power. if you would wire it to plug in, the low voltage would causes the treadmill to burn up. You will need to install a 220 volt receptacle for it to plug into and work properly. <<>> In the above answer the treadmill will not burn up but at these amperages it will make a very big flash if it shorted out. Also it must be some treadmill to draw 220 amps and I have never seen a 110 amp wall socket.
Yes.