0
Unbolt the two bolts on either side of the distributor. Disconnect the 2 lower electrical clips. Disconnect the upper clip. Slide distributor out, when re-installing it make sure the distributor "teeth" line up with the slot on the camshaft. Replug everything back in.also make sure it is on top dead centre on compression stroke or the timing will be way out!
What else can I help you with?
How do you install a distributor in a 1989 Dodge Colt?
it can only fit in one way, take the cap off and turn the rotor button slowly while you push in on the distrubter.
Where is the fuel pump for a 1992 dodge colt?
In the tank.
Where is the coil wires on a 94 dodge colt 1.5liter?
There is none. The coil is inside the distributor.
Where is the coil on a 1993 Dodge Colt 1.5 and how does a person fix it?
I believe it is located under the distributor cap. At least that's where it is located on a 1991 dodge colt 1.5 litre.
What is the firing order for a 1992 Dodge Colt 1.5L?
1432
What kind of oil to use in a 1992 dodge colt?
5w30
Why is there no fire going to the distributor on my 1992 Plymouth Colt?
Check the ignition coil or the "pick up" located inside the distributor
What might cause a 1992 Dodge Colt Vista Wagon 1.8 liter to have no spark Is the automatic shutdown relay a possibility or what?
you need a new distributor, its a very common problem with those cars
Can you put a 1991 Dodge spirit turbo engine in a 1992 Dodge colt?
It is not a direct fit.
How many oxygen sensors are in a 1992 Dodge colt 100E?
One
1991 Dodge Colt how do you turn distributor to set timing?
unscrew the distributor pull it out about half way with the distributor cap off and turn the rotor clock wise to disired position
Why does your 1992 dodge colt have any spark?
If your 1992 Dodge Colt has no spark, it could be due to several issues. Common causes include a faulty ignition coil, a malfunctioning distributor, or issues with the ignition module. Additionally, check for problems with the crankshaft position sensor or wiring and fuses related to the ignition system. Diagnosing the problem with a multimeter or by inspecting components can help determine the exact cause.
