No
The equipment grounding conductor is attached to the rounded prong in a three prong plug. Electrical work is dangerous, call a qualified electrician to install. Improper wiring could lead to personal property damage, you or someone else being injured or killed!
My question is WHY did you replace a four prong dryer plug with a three prong! 220 volt Electric dryers require two hot legs, a neutral and a system ground wire. Sounds as though you shunted one of the hots or the neutral. You need to install a four prong plug of the same configuration and wire it exactly as the original.
You can get a ground adaptor, but it is much safer to have an electrician install a properly grounded outlet. This may require having to install a new line directly to your electrical panel.
Ground wire
You should install a four prong. The older ones were three prong and had no ground. An adaptor isn't made because it wouldn't fix the problem. You could make your own adaptor and cut the ground off with a pair of dykes, but don't.
Install an AFCI breaker on the circuit with the outlets you replace and you will be fine.
The equipment grounding conductor is attached to the rounded prong in a three prong plug. Electrical work is dangerous, call a qualified electrician to install. Improper wiring could lead to personal property damage, you or someone else being injured or killed!
My question is WHY did you replace a four prong dryer plug with a three prong! 220 volt Electric dryers require two hot legs, a neutral and a system ground wire. Sounds as though you shunted one of the hots or the neutral. You need to install a four prong plug of the same configuration and wire it exactly as the original.
front of the tranny facing the radiator. its either a square six prong plug or a round plug
A qualified electrician should make the change to a dryer connection. The best way to cheaply make the change is to change the power cord on the dryer to the three hole standard.
put a 3 prong -power - load - ground, switch on the (+) side of the coil .....
The purge solenoid is located on a bracket behind the plate that the ignition coils and ignition control module sit on. Unbolt the rear nuts of the ignition plate and the bracket should slide out. Disconnect the sensor and the plastic hoses from the intake and vapor canister. Take a flat-head screwdriver and bend out the metal prong that holds the solenoid to the bottom of the bracket and the solenoid should slide right off.
A prong is a clamper to clamp things.
You can get a ground adaptor, but it is much safer to have an electrician install a properly grounded outlet. This may require having to install a new line directly to your electrical panel.
The address of the Dry Prong Branch is: 605 Russell Hataway Street, Dry Prong, 71423 0187
Is it a plastic prong sealed together
Prongs is the plural of prong