answersLogoWhite

0

join us at www.contour.org heres your answer. http://www.contour.org/mods/mods.php?s=howto&displayid=39

User Avatar

Wiki User

20y ago

What else can I help you with?

Related Questions

I have 2000 Ford Contour engine turns over but won't start What could it be?

Check for fuel and spark.


Why is your 2000 Ford Contour is sputtering when you drive?

Start with changing the fuel filter at the right front of the fuel tank, underneath, in a recess.


Where is the fuel pressure regulator locate and how do you change it in a 2000 Ford Contour 2.5 24 valve engine?

In order to change a fuel pressure regulator in a 2000 Ford Contour, start by relieving the pressure from the fuel system. The regulator is part of the fuel pump module. Place the new regulator in position in the engine and tighten any bolts.?æ


Where is 2000 ford contour fuel pump module?

The fuel pump module for a 2000 Ford Contour is located inside the fuel tank. To access it, you typically need to remove the rear seat cushion and the access panel, or alternatively, you may need to drop the fuel tank. It's essential to relieve the fuel system pressure before beginning the replacement process to ensure safety.


How to change a fuel pump in Ford Contour?

how do you get to the fuel pump on a 97 Contour romove the back seat


Where is the fuel pump on a 1995 Ford Contour?

In the fuel tank


If there a fuel pump driver module on a 2000 Ford Contour where is it?

It's located in the trunk, driver side wall behind the mat.


Where is a fuel reset button on 2000 ford contour?

The fuel pump shut off switch is in the drivers footwell , behind the kick panel . There is an access hole in the panel


Is a 1995 Ford Contour fuel injection?

Yes


Where is the fuel pump located on a 2000 ford contour?

have you checked under the rear seat? just remove the cushion and you should be able to tell if is there or not.


Fuel pump location 1999 Ford Contour?

Inside the fuel tank.


Where is the fuel rail pressure sensor on a 2000 ford contour?

It is located on the end of the fuel rail. It is held on by two small bolts. It will have a small wire harness plugged into it, and a vacuum line plugged onto the bottom of it. It is only used on returnless type fuel systems of the Contour.