i assume your wanting to change a centrifugal clutch find the master link and remove the chain the clutch will have a hex type lock screw on the front of the unit (opposite the chain side) loosen or remove the screw some systems have a additional lock nut on the front remove that as well the clutch should slide off the shaft at this time if it's been on there awhile u may have to coax it off in some cases a puller may be needed
once its off remove the steel key and clean the shaft with sandpaper and the steel key the new unit should slide on do not force it on in some cases the lead end of the crankshaft may have to dressed with a file once the unit goes on gently tap the key in and line it up with the chain if the unit has to go on backwards (chain side out) then the key will have to be installed first then the clutch tighten the lock screws
(max torque units will have two) one at the key and one at or near the opposite side of the key reinstall your crankshaft lock screw (if so equipted) and reinstall your chain
the extension clutch
The clutch of a go kart is much the same as the clutch on a car. The clutch disengages the engine from the gearbox enabling the gear to be changed. Without a clutch gear changing would be difficult and may damage the gearbox.
Answer: You can eliminate much of your overheating by having the clutch adjusted properly. you cant
Make sure the clutch is completely disengaged when pushed, it may need to be adjusted, it sounds like the clutch is dragging. get a better go kart or add a raidiatoraor even use some overheating additive...............or maybe the go kart has too much weight in it.... those clutches are supposed to slip are they?
its is a cluch
if you already have a clutch on the 140cc GX just use the chain direct to axel..
GO TO THE AUTO SHOP GO TO THE AUTO SHOP
to put the clutch on omn side of the motor theres a crak and you to the clucth on there then put the keyway in the slot or you dont have to if the clucth has a biuld in keyway
It depends on the type of kart. Rental karts - pulling cord Clutch karts - pulling cord or power button Direct drive karts - pushing
go to autozone and buy a manual. we changed our mustang clutch . the manual helps alot
You need to cut it to the right size to help it not get stuck.
To keep the cost down they use a centrifugal clutch off the engine.