You loosen the nut own the governor arm turn the arm clockwise and then turn the governor shaft clock wise. Tighten nut That should do it.
a manul to show me the way to do it
If you don't want the engine to blow up, yes.
0.030 is the gap for briggs and stratton 4.5 hp mower
were can i find a wiring diagram for a 18 hp briggs and stratton engine
You can get that info on the Briggs and Stratton website. Just go to: http://www.ereplacementparts.com/briggs-and-stratton-parts-c-16758.html?gclid=CPCZj4vGr58CFZdM5Qodp3bDsA and enter your engine model number.
Where is the location of the idle screw on the Briggs and Stratton 6.0 engine mulcher mower?
Kohler for sure
The 15.5 Briggs does not have an oil filter.
Setting the governor on a mower engine depends on whether it is a mechanical or pneumatic governor and the type of control that is used. The governor plays a very important part by keeping the engine from overspeeding and causing possible damage. I suggest you check out a book on Briggs engines at your local library and find the procedure for setting the type of governot equipped on your engine.
If the first two digits of the engine's model number are the same, the answer is yes.
Briggs & Stratton part # 491056 NAPA filter # 1348
How do I change points to electronic ignition on a 5 hp briggs & stratton small engine?