I assume that you alreay have the duct work in place, and the drywall over the duct. The problem is that there is nothing for the register screws to bite into. Instead of using the screws that come with the register, use "sleeve type - hollow wall anchors" (butterfly clips), they will expand into the space, holding the register in place. Hope this helps!
I had the same problem, so I added a couple of wire springs to the side of a plastic register (I haven't tried this with a metal one as they are heavier). A picture is worth more than words - I have a video on YouTube showing how to do this. Channel name is Grinch Biker, and video is called TWH Episode 21 - Install a heat register in a ceiling without screws.
The Wright Handyman
Is this an either/or question, or a "Should I do this or not" question? What would make the most sense would be to install your heat source as close to the floor and as far from the door as possible. Since the heat rises, this would provide the most efficient heating of the room while preventing the loss of heat from drafts by the doorway.
The short answer is wire color to color. black to black, white to white, green or bare to green of bare.
You can fill out a Hampton Bay ceiling fan warranty online. Click the register your product button from the company website.
Having the ceiling fan blow upwards will circulate the heat through the entire room.
The heat lamp would be installed where it is needed. The only place the lamp is not permitted to be placed is over a doors swing radius. This is in the electrical code to prevent a door that is left opened and in a position directly under the lamp. The heat from the lamp has the ability to raise the temperature of the door to its combustion point and set it alight.
If I am correctly understanding the question. You have a suspended ceiling and wish to add a register. Ok, two ways, the first is easiest. Get a 2`x 2` register and lay it in the grid in the place of a tile. Second, once you have selected the ceiling location for the register, lay the register in the center of the tile where it is going and trace out & cut the hole in the tile to accept the register and reinstall the tile into the ceiling grid and connect the duct. Make sure everything is properly supported and there is no stress on the tile.
Cut thin, bendable metal into a strip about 1 x 3 inches (may differ in your situation) bend two 90 degrees in it so it's a U shape. Make it in the width of your ceiling drywall. Drill a pilot hole, slide it over the edge if the register hole in the ceiling. Install screw.Basically using the metal to hold the screw in place with the ceiling panel sandwiched in between ! :)
over the toilet
TABALU
You would install a ceiling light by first reading the instructions listed in the packaging. You would then buy the right voltage of lighting and install.
It is fairly difficult to install ceiling speakers. You should hire a professional if you do not have experience doing projects like this.
Above where you stand or sit when you are wet and cold in the bathroom after bathing or showering. Not in the shower area itself.
The ceiling fan that you purchase should have instructions on how to install the ceiling fan. If not, this website walks you thru step by step: http://www.thisoldhouse.com/toh/how-to/intro/0,,453858,00.html
An Air Conditioning (ac) register is the little grille in the ceiling where conditioned air comes into a room.
Just install a cover on the ceiling box.
I want to install a pretty drop ceiling. Where can I buy the tiles for that?
Is this an either/or question, or a "Should I do this or not" question? What would make the most sense would be to install your heat source as close to the floor and as far from the door as possible. Since the heat rises, this would provide the most efficient heating of the room while preventing the loss of heat from drafts by the doorway.