To install a new clutch in a Geo Tracker, first the negative battery cable must be disconnected and the vehicle lifted on jack stands. After removing the driveshaft and all wiring connections from the transmission, the transmission should be removed. From there, a new clutch disk may be installed.
(1995) ( Geo) ( tracker ),the wheel light comes on with the hubs locked in and the shifter in , but the 4 wheel drive does not appear to be locking in.
have to completely pull tranny and 4 wheel diff.then replace clutch and re-install back in. Not for a novice,may want to leave this one to the tranny man.
how do I get to the front bearing on a geo 4 wheel drive
install a differential
There are several things that can cause your 2003 Geo Tracker four-wheel-drive not to work. The first thing you should check is the ground wire on the switch.
You will need to remove the tire and wheel from your 2002 Geo Tracker. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel seal and the wheel bearing. Reverse the process to install the new wheel bearing.
no
5w30
It is like the turn signal flasher dash light . just to remind you it is in four wheel drive.
Rear wheels if it is four wheel drive or rear wheel drive.
There are literally 100 different things that can cause your four-wheel-drive not to work. The most common cause is a disconnected wire on the four-wheel-drive selector switch.
The 2000 Chevrolet Venture is front-wheel drive and shouldn't have a fan clutch. The fans are electric.