Want this question answered?
There is no speedo cable on a Sunfire.
The 1997 Chevy Blazer shifter cable will have swivel nuts on each end of the cable. Connect the shifter cable and turn the swivel nuts to the right to install the shifter cable.
Changing transmission cables on a 2006 Pontiac vibe
Loosen the shifter cable not on each end of the shifter cable. The shifter cable will come off. Reverse the process to install the new shifter cable.
The shifter cable needs adjusted.
Depending on your engine in the 2.4 the cable is behind the filler cap for automatic transmittion fluid. then it goes all the ay down the firewall and into the shifter inside the car need to lift up the leather cover under the shifter and the hand brake as well and the you will see the bublle like conector. disengage both and put the replacement cable .
Generally, on ther throttle body. It is located 90 degrees from the accelerator cable.
unfortunately you don't.you have to purchase a new cable as these have no adjuster
The shifter cable connects the shifter to the transmission.
1) buy index shifter 2) buy new shifter wire 3) remove old shifter wire 4) remove old shifter(may require grip removal) 5) install friction shifter(if needed, install grip) 6) run new shifter cable 7) clamp cable at derailer as the derailer will have gone slack when you removed the old cable, make sure the shifter is in the right position to pull cable when you clamp the new cable in place. Trim & crimp excess cable, go ride your bike. Note:if your bike have integrated brake and shift levers you either have the choice of getting new brake levers as well, or continue to use the old but with the shifters disconnected.
Is your transmission an automatic, or a manual? I guess in either case, I'd suspect the shifter cable, or it's adjustment. Of course, something inside the transmission may have failed. Take your car to a good mechanic and have the problem diagnosed.
you just have to disconnect the shifter, take the old wires out then re wire the new ones in there