Pull of the plastic cover at the lower driver side of windshield remove the single bolt holding the wiper are to the motor remove the three bolts holding the wiper motor in place grab a new motor and reverse your order. 4 bolts total, i think 8mm and 10mm.
Purchase new blades from your local auto parts store and they will install them for free (and you get to see how it's done).
how do you replace rear wiper motor on a 1997 ford explorer
You will have to remove the wiper arms, then remove the cowl, and then the wiper motor.
how do you change wiper motor on e250 1992 van
where is the wiper controll module situated on ford galaxy
Rear Wiper Motor R&R Remove the rear pivot arm. Lift the pivot arm to the upright position. Slide the locking tab out. Pull up and remove the pivot arm. Remove the rear wiper motor shaft nut cover. Remove the rear wiper motor shaft nut. Remove the rear wiper motor cover. Remove the rear wiper motor bracket nut. Remove the bolt and the rear wiper motor. Reverse these steps to install.
Rear Wiper Motor R&R Remove the rear pivot arm. Lift the pivot arm to the upright position. Slide the locking tab out. Pull up and remove the pivot arm. Remove the rear wiper motor shaft nut cover. Remove the rear wiper motor shaft nut. Remove the rear wiper motor cover. Remove the rear wiper motor bracket nut. Remove the bolt and the rear wiper motor. Reverse these steps to install.
The 1994 Ford Thunderbird motor mounts are secured with a bolt and nut running through the middle of the motor mount. Loosen the nut and pull the bolt out.
Ford Expeditions where built from 1997 & UP... Windshield Wiper Motor Removal & Installation Front 1. Turn the ignition switch to the ONposition. Turn the ignition switch ON until the wiper blades are straight up, then turn the ignition switch OFF. 2. Disconnect the negative battery cable. 3. Remove the right-hand and left-hand windshield wiper arm and blade assemblies. 4. Remove the cowl top vent panels. 5. Detach the electrical hardness connector at the windshield wiper motor assembly. 6. Remove 3 wiper motor (module assembly) retaining bolts and remove the module assembly from the vehicle. 7. Remove the wiper linkage retaining bolt and remove the linkage from the wiper motor. 8. Remove 3 retaining nuts and remove the windshield wiper motor. To install; 9. Place the windshield wiper motor in position and install 3 retaining nuts. Tighten to 10-12 ft. lbs. (12-17 Nm). 10. Connect the wiper linkage to the windshield wiper motor and install the retaining bolt. Tighten the bolts to 14 ft. lbs. (20 Nm). 11. Place the wiper motor (module assembly) in position and install 3 retaining bolts. Tighten the bolts to 6 ft. lbs. (9Nm). 12. Install the electrical hardness connector to the windshield wiper motor. 13. Connect the negative battery cable. 14. Allow the windshield wiper motor to cycle several times while checking for proper wiper motor operation. 15. Turn the windshield wiper motor to the OFFposition to park the wiper motor in the park position. 16. Install the cowl top vent panels. 17. Install the wiper arm and blade assemblies. Install the retaining nuts and tighten to 22-29 ft. lbs. (30-40 Nm). 18. Connect the negative battery cable. 19. Check the windshield wiper motor for proper operation and the wiper arms for adjustment.
The 1996 Ford Thunderbird fan relay switch is attached to the electric fan motor. The fan motor is attached to the fan blades.
Ford Motor Company.
There were ( 2002 to 2005 ) Ford Thunderbird model years in the 2000's