Chevy Cavalier Z24

How do you install an ECM on a 1992 Chevy Cavalier Z24?

252627

Top Answer
User Avatar
Wiki User
2006-03-31 23:42:24
2006-03-31 23:42:24

remove the glove box(9 or 10) t-15 torx bits, remove one trx bit from the ecu carraige(white plastic) pull the ecu out, and unclip the 3 connectors.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

under the hood on the passenger side looks like a little grill with a plug or 2 in it !---------------!=! !---------------! !==== !---------------!=! !---------------!=! !---------------! !==== !---------------!=!

User Avatar

Unhook the battery. Remove the glove box door. You'll see the ECM. Unplug the wires to it. There are four nuts that hold it in. Loosen them and take out the ECM. Reverse the procedure to install. Remember to put your original PROM chip in the new ECM.

User Avatar

The ECM on a 1992 S10 Blazer is located below the glove box.

User Avatar

The ECM will be programmed to shut it down around 105 mph.

User Avatar

IT IS LOCATED INSIDE THE PASSENGER SIDE FENDER WELL BEHIND THE BUMPER COVER.

User Avatar

Inside the dashboard, to the right of the glove box.

User Avatar

remove glove box panel ecm is located behind panel

User Avatar

I believe but not sure... I thing it is under the capet and the passengers feet... Nope...The right front fender....

User Avatar

You don't, it is done by the ECM (Engine Control Module).

User Avatar

depends on engine, mounting, body, ecm, and about a million other things, but possibily

User Avatar

Where is the ecm located in a 2000 Chevy Malibu

User Avatar

Take the inside of the glove box out and look into the right side and you will see it.

User Avatar

It's located at the front of the passenger front fender, inside the plastic splash shield. You would need to remove the horn to get to it.

User Avatar

you can bolt up engine but you will more than likely have to exchange exhaust manifold as well as the computer  ecm/pcm/ecu its diffently not p[lug and play  

User Avatar

NO it will not. You MUST have a 1983 ECM/computer that is programed for that make a model car.

User Avatar

where is the ecm unit in a 1997 Chevy Malibu 3.1 6 cly

User Avatar

What all does the ECM computer control on my 2006 Chevy k1500 Silverado

User Avatar

it is behind the drivers side speaker u have to remove the speaker, und bolts on ecm and lift it out. then you put in the new one a plug it in. no programming is required.

User Avatar

Where is the ecm fuse on a 1994 chevy truck

User Avatar

The only way to "disable" the "governor" is to reprogram the ECM to delete the fuel cut off point.

User Avatar

1992 sunbird is obd1,1996 firebird is obd2.Will not work.

User Avatar

simple passenger side inner fender well. unplug multi-pin connector after loosening retainer screw (inside wire bunch) remove three ecm retainer screws, reverse procedure to install new ecm!! YOUR DONE

User Avatar

do you have link and program a 88 cilverado ecm when replacing


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.