Want this question answered?
It's located on the steering column 2 screws unplug the harnest
The 1991 Mercury Sable ignition switch is held in place with a retaining ring. Loosen the retaining ring. Pull the ignition switch out. Remove the wiring harness from the rear of the ignition switch. Reverse the process to install the new ignition switch.
Be more specific in your question. You haven't asked anything yet.
on a 1997 Mercury Grand Marquis kill switch be activated by a rear end collision
For a 1988 Mercury Marquis remove bottom shroud from steering column (5 Philips head screws). There is a wire running from the ignition switch to the left side of the steering column; detach it from the coupler (This can be done without a tool). Turn key to ON position until the panel lights come on. There is a small pin near the bottom of the key lock; push it in and pull the ignition switch out (don't panic if the wire seems to be stuck; it will come out). To replace, turn new ignition switch to same position. Push pin on the ignition switch in while sliding it back into the steering column. Reconnect wire and then replace shroud.
The 1986 Mercury Marquis does not have a fuel cutoff switch. The fuel pump does have a fuse, of which could render it as nonworking.
how can you start a '89 mercury cougar with a broken ignition switch?
To remove a ignition switch from a 1963 mercury meteor you must turn it off then unscrew it.
how do you install new ignition switch on 1989 chevy G10 van?
I experienced a problem with a 84 Grand Marquis that would stall at stops. Found that the ignition switch in the steering column had separated that caused the stalling problem. Replaced the ignition switch that solved the problem.
Begin by removing the retaining ring at the top of your 1996 Mercury Tracer ignition switch. The ignition lock cylinder will slide out. Remove the wiring harness from the end of the cylinder. Reverse the process to install your new ignition lock cylinder.
Remove the ignition switch retaining ring. Pull the ignition switch out. Remove the wiring harness from the back of the ignition switch. Reverse the process to install the new ignition switch.