Want this question answered?
We do not register hotels for people on this site. I suggest you contact "pan India" and ask them how to do this.
How do you install a oil pan gasket on 1995 Lexus sc400
Above the oil pan, you need to take of the timing belt, timing belt rear cover, then the oil pan.
ive found that if you remove the front side engine mount located on the passenger side place a jack with a block of wood under the pan, raise the engine up until you get better access to the belt tentioner, its easier to do this way, also if you remove the lower engine cover you'll have access to the belt too. relieve the tention on the belt with either a belt tool or a 13mm wrench, remove the serp belt half way, unbolt the tentioner, install the new one reinstall the belt, check all area's and alingment. drop the engine back down install the mount start the car up and check the belt and then install the lower engine cover, why your there might as well replace the belt for maintence purpose...hope this helps
From under the 2003 Ram, loosen the lowest power steering hose, and let the fluid drain into a pan. Remove the power steering belt. Remove the fluid lines, and unbolt the pump. Install the new pump, hook up the lines, and re install the belt. Fill up with new fluid.
To install a floor pan in a VW beetle, first remove the seats and floor carpet. Also remove heater tubes, battery and rear support. Finally, arrange the floor pan and tighten the pan bolts.
take both motor mount bolts out and jack engine up high enough to get the bolts out of the pan and take the pan out, scrape the old gasket off and clean pan inside and out and install new gasket with permatex to hold it in place and let it dry for about 15 minutes and then re-install pan and pan bolts.
Drain the oil from the oil pan. Remove the oil pan. Unbolt the old oil pump. Reverse the process to install the new oil pump.
You remove the pan, clean the pan, change the filter, install new pan gasket, and fill fluid.
install shift kit by removing trans or drop pan and install upgraded solnoids in valve body
R&R transmission pan and replace filter in pan..?
$500