fitted the hinges but door drops
Read the instructions first. It is difficult to fug up this job because you can install them backwards or upside down. Take a good look at them and learn how they work,
installing a double action spring hing
A double action hinge is really no different that a regular one. Simply place where desired, mortise them in and install. If it is confusing, look at it as if it was only opening one way at a time. One direction it uses the outside part of the hinge and for the other direction it uses the inside part. As long as you install each hinge on the same edge or in the same direction they work the same as a regular hinge. You are limited as to the thickness of the door you are using and there can not be any door stop as the door must swing both ways. But there is a floor mounted double acting hinge that does require a little bit of preparation before installing: http://floorhinge.doorlocksanddeadbolts.com/
You don't have anything following, but an example would be the typical double barreled shotgun.
To adjust a double hinge, open the hinge and locate the screw on the side. Use a screwdriver to tighten or loosen the screw to adjust the tension of the hinge. Test the hinge after making adjustments to ensure the door opens and closes smoothly.
To install a self-closing hinge, first, remove the existing hinge from the door. Then, attach the self-closing hinge to the door using screws. Next, attach the other side of the hinge to the door frame. Adjust the tension on the hinge to control the closing speed of the door. Finally, test the door to ensure it closes properly.
To replace the hinge on a 95 Mercury Cougar, remove the bolts holding the hinge in place. Find a replacement hinge from the manufacturer and install it using the right hardware.
The theorem emulates the action of a hinge. As the angle of the hinge is increased the distance between the free edges increases.
To properly install a bench seat hinge in a vehicle, first, remove the old hinge if necessary. Then, align the new hinge with the mounting holes on the seat and the floor of the vehicle. Secure the hinge in place using the appropriate screws or bolts. Make sure the hinge is securely attached and the seat can move smoothly. Test the seat to ensure it functions properly before use.
A break or hinge action pistol is a type of firearm that operates by pivoting or "breaking" open at a hinge point, typically near the chamber. This design allows the shooter to easily load and unload ammunition, often found in single-shot or double-barreled pistols. An example of a break action pistol is the "Taurus Model 66," which can be opened for reloading by breaking the barrel down. These pistols are less common than other action types but are valued for their simplicity and ease of use.
To properly install a hinge shim for a secure and stable door, place the shim behind the hinge on the side where the door is sagging. Use a screwdriver to tighten the screws on the hinge, ensuring the shim is securely in place. This will help align the door properly and prevent it from sagging.
Installing a butterfly hinge is the same as installing any regular hinge. Measure all the dimensions carefully, determine and trace where the hinge will be allowing proper clearance, and screw the hinge in until completely tightened using proper tools and techniques.