What I found is to take off bottom part of the Grill which is held on by Philips head screws, easy to get to. Then using a 10mm socket unbolt the top bolt holding on the headlamp assembly. Now the tricky part. There are 2 10mm nuts holding on the headlamp assembly inside the fender. You must unbolt the wheel well plastic liners, but not all the way. Only take off the bottom 3 10mm screws from under the bumper and the 2 10 mm screws inside the front portion of the wheelwell. Then using a small Phillips head screw driver unscrew the first 2 screws inside the lip of the wheelwell. This should allow you to pull back the liner and reach inside the wheelwell and unbolt the headlight assembly. The top nut use a short extension on the socket and the bottom nut use a long extesion. And the headlight assembly should tilt up slightly and pull out enough to remove the wiring hookups. Remember you will need to save the nuts you take off because they do not come with the new assembly. Also install the black trim piece in the headlamp prior to installing. Total time 2 hours for 2 headlamps.
Take the new antenna and your RX300 to Circuit City. They will install it for about $50.
How do you change the spark plugs in 2001 lexus rx300?
Tune up for 1999 rx300 Lexus
look in your owner's manual
Lexus manufacturer recommend replace timing belt on Lexus rx300 every 105,000 miles.
how do you remove the glovebox in an rx300 lexus 2002
need change knock sensor 2 bank 2 in 2000 lexus rx300
Japan
What about them?
The PCV valve for a 2000 Lexus rx300 is on the passenger side of the engine. It is on the valve cover near the back.
Go to your local Lexus Dealer. Or get an M.O.T
The brake light assembly can be access through the cargo compartment. Remove the cover to the brake light assembly. Take hold of the brake light connector, push in and turn at the same time. The brake light will come out. Reverse the process to install the new brake light.