remove steering wheel with a puller, remove turn signal switch, remove tilt steering spring by pushing down and turning slightly counter clockwise, this should give you access to the torx screw . remove this screw and slide ignition lock cylinder out
cutlass supremes are so baller
Remove fuel tank for access
It takes a special gauge to install the crank sensor. It can be rented from some parts stores.
Take the gas tank down as the pump is inside the gas tank.
Replacing the brake pads on your 1982 Oldsmobile Cutlass is quite easy. Remove the brake pad Springs and caliper. The brake pads will come off. Reverse the process to install the new brake pads
sounds like pump is going, install new pump
go to the parts store and get a rear view mirror mounting kit and follow the instructions to a T.
Remove the oxygen sensor vacuum to. Remove the oxygen sensor screws. Reverse the process to install the new oxygen sensor.
Remove the wiper arm from your 1999 Oldsmobile Cutlass wiper motor. Remove the wiper motor wiring harness. Remove the wiper motor retaining bolts. Reverse the process to install the new wiper motor.
Stick the starter in the cutlass supreme.
Remove the wiring harness from the back of your 1995 Oldsmobile Cutlass blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install your new blower motor.
Remove the oil pan, unbolt the pump, install the new pump,the pump drive is off the bottom of the distributor and must be aligned to go in properly.