Want this question answered?
the answer is no. 2002 was the first year the liberty was made. in 2003 they change the computer modules..the only engine you can put in a 2002 jeep liberty is a 2002 engine
The oil pressure gauge on a 2002 Ford Taurus is located right next to where the battery is, toward the middle of the actual car. The gauge is connected to the front of the engine.
Remove the instrument panel cover from your 2002 Subaru. Remove the fuel gauge retaining screws. Remove the wiring harness from the back of the fuel gauge. Reverse the process to install your new fuel gauge.
With a fuel pressure gauge attached to the fuel rail.
The 2002 Jeep Liberty rear wiper blade is unique to Jeep. You'll probably have to get the part at the dealer and may be able to ask for the install procedure.
Remove the oil sending unit and install a mechanical gauge. Start the engine cold and let it warm up to normal operating temperature. It the oil pressure is correct then replace the oil pressure switch.
Trouble code P0108 means:Manifold absolute pressure/barometric pressure circuit high input
Just in front of crossmember, passenger side and near the bottom.
check fuse 3 and fuse 13 . not making good contact.
On a 2002 Ford Ranger : The check " gage " light comes on if : The engine coolant temperature is TOO HIGH The engine oil pressure is TOO LOW or The fuel gauge is at or near empty
The tire will have the pressure on the sidewall. I have seen 44psi there, but, that feels a little hard to me. I have kept them at 40psi and been just fine. The pressure listed on the side of the tire is the max safe pressure for that tire. The recommended pressure for a Jeep Liberty is on the label affixed to the driver's door jamb. It is more in the 30-35 psi range.
You will need to remove the front tire and wheels from your 2002 Jeep liberty. Remove the brake pads and break assembly. Tap the rotors with a hammer or mallet. The rotors will come off. Reverse the process to install the new rotors.